LEGRAND PLUGMOLD PM48TC User manual

PLUGMOLD®
PLUG-IN UNITS
I N S T A L L A T I O N I N S T R U C T I O N S
WARNING: For maximum safety, Plugmold Plug-In Units are
equipped with a grounding type plug 3-prong) for use
only with grounding type receptacles. Modification of
the plug to allow its use in non-grounding receptacles
voids the warranty and may lead to electrical shock.
1. Determine the installation location and rotate the
Plugmold Plug-In Unit to the necessary orientation
as ollows:
a. Loosen the 2 phillips head screws near the plug
blades. Do not ully remove the screws.
b. Pull the rotating section o the plug outwards and
rotate to the desired orientation. The Plugmold
Plug-In Unit will rotate in 90° increments only.
c. Push in the rotating section o the plug and tighten
the 2 phillips head screws.
2. Plug the Plugmold Plug-In Unit into the desired
receptacle, hold securely, and mark the wall on top
and bottom o the Plugmold Plug-In Unit where the
mounting clips will be installed.
INSTALLATION:
Legrand/Wiremold electrical systems con orm to and should be
properly grounded in compliance with requirements o the current
National Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or ire hazard i
improperly installed or used. Legrand/Wiremold electrical products
may bear the mark o a Nationally Recognized Testing Laboratory
(NRTL) and should be installed in con ormance with current local
and/or the National Electrical Code.

1 010 518 0811
© Copyright 2011 Legrand/Wiremold All Rights Reserved
WIREMOLD
U.S. and International:
60 Woodlawn Street • West Hart ord, CT 06110
1-800-621-0049 • FAX [phone] • Outside U.S.: 860-233-6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX [phone]
. Unplug the Plugmold Plug-In Unit and install the
mounting clips on the wall. IMPORTANT – i the lat
head screws urnished are not used, the substitute
asteners must also be o the lat head type, or the
unit will not seat securely in the mounting clips.
4. Plug the Plugmold Plug-In Unit into the receptacle
and snap into the mounting clips.
INSTALLATION continued):