Lippert FLYSCREEN N Series User manual

Whenever, wherever,
we make your experience better.
STRINGS ADJUSTMENT TENSION MANUAL
FLYSCREEN N-SERIES
Plant 310
TI-429 CCD-0006419

INTRODUCTION
Looking at the flyscreen, keep its sloping side on the right.
On the flyscreen there are 5 wire clamp plates:
12
3 54
TI-429 CCD-0006419

Place the handle of the flyscreen in
closed position and hold it.
Slightly unscrew the stud bolt N° 1
or N° 5 as needed with a 2 mm
allen wrench until the wire clamp
plate is free to move.
Move the wire clamp plate as
shown in the picture to increase or
decrease the string tension.
ADJUST STRAIGHT SIDE
12
3 54 Decrease Increase
Increase Decrease
LEFT RIGHT
LEFT RIGHT
Closed
position
TI-429 CCD-0006419

ADJUST STRAIGHT SIDE
If the handle is moved
forward at the top of fly
screen, it means that
the tension of the ropes
in the upper guide is too
high.
Reduce the tension of
the ropes N°1.
If the handle is moved
forward at the bottom
of fly screen, it means
that the tension of the
ropes in the lower track
is too high.
Reduce the tension of
the ropes N° 5.
When the handle is in
the vertical position, it
means that the string
tension in the upper
track and in the lower
track is correct. Screw
the bolt studs N°1 and
N° 5 to lock the strings
in the desired position.
If too much force is
required to move the
handle, loosen the
cords in both the upper
and lower tracks
slightly.
If the rope tension is too
high, the handle will be
more difficult to move.
If the rope tension is too
low, the handle may get
stuck on the way.
TI-429 CCD-0006419

Place the handle of the flyscreen in closed
position and hold it.
Slightly unscrew the stud bolt N° 3 or N° 4 as
needed with a 2 mm allen wrench until the
wire clamp plate is free to move.
Move the wire clamp plate as shown in the
picture to increase or decrease the wire
tension.
ADJUST SLOPING SIDE
12
3 54
Closed
position
Increase Decrease
LEFT RIGHT
TI-429 CCD-0006419

ADJUST SLOPING SIDE
If the strings that pass
throught the net are
loose, increase the
tension of clamp plate
N°4.
If the wires that pass
throught the net are
too tight, decrease the
tension of clamp plate
N°4.
When the desired
position is achieved,
screw the bolt studs
N°4 to lock the strings.
If the crawler tends to
get stuck, increase the
tension of clamp plate
N° 3.
If the handle is hard to
move, decrease the
tension of clamp plate
N°3.
When the desired
position is achieved,
screw the bolt studs
N°4 to lock the strings.
If the rope tension is too
high, the handle will be
more difficult to move.
If the rope tension is too
low, the handle may get
stuck on the way.
TI-429 CCD-0006419