METHVEN Ovalo Wall Top 01-0806 User manual

Ovalo Wall Top Assembly
Installation Guide
Illustration may not reflect actual product shape.
www.methven.com
Use of this product in non-domestic applications voids warranty.
All pipe work must be thoroughly flushed prior to the installation of the mixer.
NEFA inline filters must be installed on both hot and cold supplies.
Do not remove the ceramic cartridge from the mixer when installing.
Damage caused by hydrostatic testing is not covered by our warranty.
IMPORTANT
Please read all of the instructions before installation
01-0806 (Pair)

OCT 2010 MA433509
THE METHVEN GUARANTEE
The warranty statement shall apply to all tapware & showers supplied by Methven
For more information visit www.methven.com
THIS WARRANTY ISSUED BY: Methven Australia Pty Ltd, Melbourne Australia
We recommend that this product is installed by a licensed plumber.
Methven Australia Pty Ltd
ABN 15 104 813 390
Melbourne, Australia
www.methven.com
Technical Specifications
STANDARD WALL-TOP ASSEMBLY
Inlet Connections: All 1/2" BSP
Operating Pressure: 150kPa - 500kPa
Operating Temperatures: Recommended hot water supply 50°C,
maximum 70°C. AS 3500 requires all hot
water supplies to any sanitary fitting to be
tempered to 50°C.
Recommended Rough in Set up: Face of finished wall to front of breech
(body) 6mm
Tolerance: Min: 0mm Max: 12mm
Adjustment For Handle Line Up.
The spindle can be tightened allowing
the handle to be adjusted on the spline.
Flange
Locking Nut
O Ring
Spindle
Grub
Screws
Flange
Connection
Standard Spindle &
Handle Assembly Set up
Flange Male Adaptor
04-9905
Spindle Only
Hot 04-9752
Cold 04-9769
Extended Spindles (Not Included)
Hot 04-9707
Cold 04-9714
Flange Male Adaptor 04-9899
Standard Spindle
12mm Extension
04-9837
(Not Included)
Spindle Flange M & F
Extension 04-9875
(Not Included)