METHVEN KIRI SATINJET ULTRA LOW FLOW User manual

KIRI SATINJET ULTRA LOW FLOW
SHOWER HEAD/HANDSET
INSTALLATION GUIDE
TECHNICAL SPECIFICATIONS
Operating Pressure:
Min 1 bar, Max 5 bar.
If supply exceeds 5 bar a pressure
limiting valve must be installed.
Operating Temperature:
Max 70°C.
Issue A435013
Methven warrants this product against manufacturing defects and that it is suitable for use
under the operating conditions specified in this instruction sheet.
For your warranty please refer to www.methven.com or call Customer Service
New Zealand
0800 804 222
Australia
1300 638 483
UK
0800 195 1602
Notes:
After installation all connections●
must be checked for leaks.
All installations must be carried●
out in compliance with relevant
water regulations.

Remove existing handset from hose. Insert the filter
washer into the hose before screwing to Kiri Ultra
Low Flow Handset.
Remove existing shower head from arm. Remove
cap from Kiri Ultra Low Flow Handset shower head.
Screw shower head onto arm. Straighten shower
head so it is in the correct orientation.
Water contains lime which remains on the surface
after the water has evaporated. These lime
deposits can be prevented from forming by wiping
immediately after use.
To clean the chrome-plated surfaces use a soft
cloth, soap and warm water. Never use cleaning
agents that contain a corrosive acid or a scouring
additive.
CLEANING
Do not use any
sharp objects to
clean nozzles.
Clean filter washer
periodically.
Filter Washer
ULTRA LOW FLOW SHOWER HEAD
INSTALLATION
ULTRA LOW FLOW HANDSET INSTALLATION