miseno MLK3090BK Guide

TAR-EN1
INSTRUCTIONS FOR KNOBSETSINSTALLATION OF TUBULAR
DETERMINE HANDING OF YOUR DOOR
Stand at exterior side and face to your door.
Your door is left hand door if hinge were installed at your left hand.
Your door is right hand door if hinge were installed at your right hand.
Hinge
RIGHT HAND DOOR
EXTERIOR
LEFT HAND DOOR
Hinge
a. This latch is set for
2-3/8" (60 mm) backset.
b. Keep spindle cam in correct position
as illustrated.
Pull spindle cam all the way to right.
c. Your latch is now set for 2-3/4" (70 mm) backset.
To reset 2-3/8" (60 mm) backset, just push spindle
cam back to left side.
Please make sure that the cams are staying with
square shape.
a. b. c.
ADJUSTABLE LATCH FOR 2-3/8" (60 mm) AND 2-3/4" (70 mm) BACKSET
TAR-EN1
Outside Assembly Strike Plate
Latch
Inside Assembly
PACKAGE CONTENTS TOOLS NEEDED (NOT INCLUDED)
Keys Removal Tool Latch/Strike Screws Qty. 4 Mounting Screws Qty. 2
Phillips Screwdriver
Tape Measure
Backset is a distance from the door edge to the centr of the hole on door face.
Some locks are supplied with adjustable latch which can fit 2-3/8" (60 mm) or 2-3/4" (70 mm) backset.
Just follow the steps shown below to change backset.
e
1-3/8"-1-3/4"
35 mm-45 mm
1"
25.4 mm 2-1/8"
54 mm
2-3/8" (60 mm)
or
2-3/4" (70 mm)
backset
Use enclosed to mark holes on door face.
Drill Ø2-1/8" (54 mm) holes from both sides of door.
Drill Ø1" (25.4 mm) holes in door edge for latches.
template
PREPARE DOOR AND CHECK DIMENSIONS

a.
b.
c.
Close door to make horizontal cent e line
of strike.
r
Measure one half of door thickness from
door stop and mark vertical centre line
of strike.
Drill 1"(25 mm) hole 1/2"(13 mm) deep at
intersection of horizontal and vertical line
of strike.
Match screw holes on strike with centre
lines on jamb.
Mark outline and chisel 1/16" (1.6 mm)
deep for strike.
Install strike and tighten screws.
Ø2-1/8" 54 mm ( )
FOR BACKSET ( )2-3/4" 70 mm
FOR BACKSET ( )2-3/8" 60 mm
45 mm 40 mm 35 mm
1-3/4" 1-3/8"1-9/16"
Make 1"(25.4 mm)hole at center of door edge.
Fold on dotted line and fit on door edge
TEMPLATE
3. INSTALL LATCH
Insert latch in hole and keep it parallel
to door face.
Mark outline of face plate and remove latch.
Chisel 1/8" (3 mm) deep or until
face plate flush with door edge.
Insert latch and tighten screws.
4. INSTALL OUTSIDE KNOB 6. INSTALL STRIKE
a. b.
c.
Install inside knob and tighten screws until lock is firm.
Insert spindle through latch.
Press flush against door.
NOTE: Key hole must be in down position.
5. INSTALL INSIDE KNOB
Customer service 1-800-221-3379