Mocka Essentials Coffee Table User manual

*We recommend using a Flathead screwdriver to tighten all locking nuts 100% before first use.
Please clear any loose wood from the locking nut holes before inserting the nut to ensure it locks 100%.
Hardware Supplied
bolt
x12
B
A
locking
nut x12
CDE
screw
x8
leg
x4
cover
x12
35 mm
Phillips & Flathead screwdrivers required
1
mocka.co.nz | mocka.com.au
Mocka Essentials Coffee Table
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.

12
To begin assembly first screw in 12x bolts (B) into holes in both top and
bottom panels [2 & 3].
Slide three vertical panels [1] onto the screw tops in the correct position
as shown. Insert 6x locking nuts (A) into the lower holes in side of panels
and tighten with screwdriver.
2
B
3
B
2
Ax2
A
A
A
A
1
1
1
A
x6
B
x6
B
B
B
B
B
B
B
B
B
B
2
mocka.co.nz | mocka.com.au
Mocka Essentials Coffee Table
Assembly Instructions

12
To begin assembly first screw in 12x bolts (B) into holes in both top and
bottom panels [2 & 3].
Slide three vertical panels [1] onto the screw tops in the correct position
as shown. Insert 6x locking nuts (A) into the lower holes in side of panels
and tighten with screwdriver.
2
B
3
B
2
Ax2
A
A
A
A
1
1
1
A
x6
B
x6
B
B
B
B
B
B
B
B
B
B
34
Place base panel [3] with bolts (B) already attached into holes on top of
vertical panels. Insert 6x locking nuts (A) into remaining holes in all
verticals panels [1] and tighten with screwdriver.
Attach all feet (D) to the base panel [3] using 2x screws (C) in each.
Ensure all screws are securely tightened with a screwdriver.
3
A
A
A
A
A
A
A
x6
D
3
C
3
mocka.co.nz | mocka.com.au
Assembly Instructions
Mocka Essentials Coffee Table

56
Flip table over so feet sit on the floor. Check all screws and hardware
are secure. Lift furniture into desired position, do not drag.
To finish use (E) to cover the holes where hardware (A) is used.
You’re done, enjoy!
Mocka Essentials Coffee Table
Assembly Instructions
4
mocka.co.nz | mocka.com.au