Mocka Toy Box User manual

Phillips & Flathead screwdrivers required *We recommend using a Flathead screwdriver to tighten all locking nuts 100% before first use.
Please clear any loose wood from the locking nut holes before inserting the nut to ensure it locks 100%.
Wooden Toy Box
1
mocka.co.nz | mocka.com.au
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.

12
To assemble the Toy Box first insert 4x wood dowels (H) into each front
and back panel [2] and [3].
Fasten side panel [1] to panels [2] and [3] using 4x bolts (A) and 4x nuts
(B). Ensure the grooves on the panels all align. Tighten all bolts with a
screwdriver.
Wooden Toy Box
2
mocka.co.nz | mocka.com.au
Assembly Instructions

12
To assemble the Toy Box first insert 4x wood dowels (H) into each front
and back panel [2] and [3].
Fasten side panel [1] to panels [2] and [3] using 4x bolts (A) and 4x nuts
(B). Ensure the grooves on the panels all align. Tighten all bolts with a
screwdriver.
34
Next slide the base panel [5] into the grooved slots in the panels. Repeat Step 2. Fasten side panel [1] to panels [2] and [3] using 4x bolts
(A) and 4x nuts (B). Ensure the grooves on the panels all align. Tighten
all bolts with a screwdriver.
Wooden Toy Box
3
mocka.co.nz | mocka.com.au
Assembly Instructions

56
Attach the two brackets (E) to the spaces in panel [3] using 2x small
screws (C) in each. Tighten screws with a screwdriver.
Then fasten the Toy Box lid [4] to the brackets (E) using 2x small screws
(C) in each. Tighten screws with a screwdriver.
Wooden Toy Box
Assembly Instructions
4
mocka.co.nz | mocka.com.au

Jolt Wardrobe
ASSEMBLY INSTRUCTIONS
5
mocka.co.nz | mocka.com.au
56
Attach the two brackets (E) to the spaces in panel [3] using 2x small
screws (C) in each. Tighten screws with a screwdriver.
Then fasten the Toy Box lid [4] to the brackets (E) using 2x small screws
(C) in each. Tighten screws with a screwdriver.
78
Attach the compression hinge (F) in place using 4x screws (D). Ensure
the hinge is fastened to both lid [4] and back panel [3] using a
screwdriver. Check the lid easily opens and closes.
Ensure all screws and bolts are secure but not over tightened before
use. Finish by covering bolts holes with hardware (G). All done, enjoy!
Wooden Toy Box
Assembly Instructions
5
mocka.co.nz | mocka.com.au