molex 69020-2025 User manual

A.S. 06.07.04 ISSUE C
FILENAME: ATS-69020-2025c
ARBOR PRESS FIXTURE
PART No. 69020-2025
FOR MOLEX PRODUCT ENG. No 91317
DESCRIPTION
This fixture is used to terminate Molex connector 91317, 3 to
16 ckt. onto pre-cut ribbon cable.
FEATURES
1. This fixture can only be used in a standard Arbor Press
part No. 69020-0660.
2. Adjustable from 3 to 16 ckt.
3. For loose piece terminals only.
4. Hand loading of connector and cable.
SPECIFICATION
SIZE: 100mm x 100mm x 50mm
WEIGHT: 1.25 kg
WORKING SERVICES: None.

A.S. 06.07.04 ISSUE C
FILENAME: ATS-69020-2025c
SET-UP
1) Place lower termination fixture onto mounting platform of
Arbor Press, locating it onto the two mounting pins.
2) Adjust positioning bars to keep connector central on the
base plate.
3) Make a few samples following the next section (operation)
and then check termination heights. If adjustment is
required see adjustments section.
OPERATION
1) Insert connector into lower termination block.
2) Push pre-cut ribbon cable into connector.
3) Pull handle down fully to terminate connector.
4) Turn handle to start position.
5) Remove connector from fixture.

A.S. 06.07.04 ISSUE C
FILENAME: ATS-69020-2025c
ADJUSTMENTS
1) If termination height is incorrect then follow the
procedure below.
2) Loosen the stud nuts in the centre of the Arbor Press.
3) Loosen clamp bolt to column at the rear of the Arbor
Press.
4) Adjust upper part of Arbor Press up or down using the two
nuts on the central stud.
5) Re-tighten nuts and clamp bolt.
6) Recheck termination height.
MAINTENANCE
1) Keep fixture clean at all times.
2) Clean fixture with brush.
3) Oil moving parts weekly, when in use.
4) Store in a clean dry environment.
QUALITY
Check termination quality against the Molex wire termination
specification for relevant product being terminated eg: PS-
90650.
A quality procedure should be in place to monitor output from
this fixture.
LIMITATIONS
This Arbor Press Fixture can only be used for product stated
in the description of this leaflet.