MRC SI-100N User manual

Vortex mixer for tubes
SI-100N
Operation Manual
PLEASE READ THIS MANUAL CAREFULLY BEFORE OPERATION
Hagavish st. Israel 58817 Tel: [phone], Fax: [phone] [email protected]
MRC.4.18

INSTRUCTION MANUAL FOR VORTEX MIXER SI-100N
Op
tion-1 Option-2
Warnings:
* Do not remove the mixer during operation.
* Place the mixer securely away from the edge of bench to avoid the mixer falling off the bench top.
* Do not disassemble the mixer by yourself. In the event of a malfunction, the mixer should be repaired by a
qualified technician. Before repairing, turn off the power.
Steps:
1. Place the mixer on a flat and stable bench top. Plug the mixer into a properly grounded outlet which
corresponds with the electrical requirements on the label back on machine.
2. Place the ‘Switch’ at ‘TOUCH’ position. The unit will run as soon as touch on the ‘Head’. The ‘Power
indicator’ lights.
3. Place the ‘Switch’ at the ‘AUTO’ position, the unit will run automatically. The ‘Power indicator’ lights.
4. Turn the ‘Speed controller’ to the required speed.
Warning: Do not make the motor race rotation to avoid damage. After finishing operation, please place the
switch at ‘TOUCH’ or ‘OFF’ position.
Maintenance and care:
Keep the machine clean all the time, so no routine maintenance is required. Cleaning can be done with a
damp cloth. Avoid the use of solvents as they may damage the machine housing.
Circuit Diagram
Heads
Speed controller Switch
(AUTO/OFF/TOUCH)

Service Manual
Troubleshooting Guide
Caution: Always disconnect the power cord before troubleshooting.
Trouble Cause Remedy
Power cord not connected to outlet. Plug in the power cord.
Dead power output. Change to different output.
Instrument inoperative
Defective electronic component. Contact your distributor for repair.
Switch isn’t at ‘AUTO or “TOUCH’ position. Placethe switch at ‘AUTO or “TOUCH’ position.
Eccentric brass rod doesn’t work well. Contact your distributor for repair.
Switch is broken. Contact your distributor for repair.
Motor is broken. Contact your distributor for repair.
Head doesn’t rotate
PC board is broken. Contact your distributor for repair.
PC board is broken. Contact your distributor for repair.
Speed can’t not be controlled Speed controller is broken. Contact your distributor for repair.
Eccentric brass rod doesn’t work well. Contact your distributor for repair.
There is a big noise during
operation Belt which is to fix the eccentric brass rod
doesn’t work well. Contact your distributor for repair.
The wiring of PC board and the power
indicator is not well. Contact your distributor for repair.
Power indicator can not light
up The power indicator is broken. Contact your distributor for repair.
Switch isn’t at “TOUCH’ position. Place the Switch at ‘TOUCH’ position.
The “TOUCH” function can’t
work The starting button under the motor is broken. Contact your distributor for repair.