MRC WBH-060N User manual

3, Hagavish st. Israel 58817 Tel: [phone], Fax: [phone]
[email protected]
Digital Bath
With Internal/External circulation
WBH-060N

3, Hagavish st. Israel 58817 Tel: [phone], Fax: [phone]
[email protected]
General Remarks
•Do not turn on the bath without liquid.
•Do not fill oil or any other material that is not water.
•Distilled water should be filled, not tap water, to avoid scale
•Liquid must be filled at least 90% of the tank volume.
•Do not overfill liquids, that can spill out during operation.
•Attention should be paid to the level of the liquid especially in
external working condition and to fill the liquid if the water level is
not enough.
•Make sure that before operating, the lid is placed and closed tightly.
•Do not clean the bath or internal container with acids or corrosive
substances.
•Do not allow foreign objects to enter the internal tank and block the
circulating mechanism and circulation motor
•Make sure to use distilled water, not tap water, to prevent from scale
to buildup in the heating element, circulating mechanism and all
components of the system.
•Do not block the ventilation openings of the control system.
•Do not spill liquids or wet the controlling system to avoid shock
hazard and damage to the bath.
General Description
Front View:

3, Hagavish st. Israel 58817 Tel: [phone], Fax: [phone]
[email protected]
Rear View:
Digital Controller

3, Hagavish st. Israel 58817 Tel: [phone], Fax: [phone]
[email protected]
Working instructions and temperature adjustment:
1. Connect pipes to the inlet and outlet connectors of the appliance
according to use (external or internal circulation).
2. In external working mode, pay attention to the flow direction from
the connectors and connect the pipe accordingly.
3. Fill liquid at least 90% of the tank volume.
4. Pay attention to the level of the liquid especially in the external
working condition and fill the liquid if needed.
5. Plug the power cord into the 230VAC power supply and turn on the
unit with the main power button.
6. Adjust the desired temperature with the "Up key" button on the
controller and confirm with the "scroll key" button.
Important note:
Do not enter the internal configurations of the controller unnecessarily and
do not change values other than the required temperature values.