Nibe Contura C30 User manual

Fläkt C30
Fan C30
Monteringsanvisning 2
Installation instruction 5 Monterings-
anvisning
SE
GB
contura.eu

GB
5
General
Read through the entire installation instruction before
installing the fan. The fan is installed under the heart
and the installation is usually concealed by a plinth.
The plinth is a separate accessory. The fan increases
the heating from the stove and makes the air in the room
circulate which gives better heat distribution and a more
even temperature.
Preparations
Unpack and check the contents. For supply air
connection from outside, a distance of 75mm is required
between the condensation insulation and the heart. This
is to make space for the fan.
Remove the heat deflector plate, it is not
required when the fan is installed.
Tap out the knock out on the
rear side of the stove.
The fan is powered by 230V, ignoring the
instructions is potentially lethal. The fan or its
components must not be worked on. Impacts
on the cable sheaths are potentially lethal. If
there is a fault in the fan it must be returned
to the place of purchase.
!
!
This appliance may be used by children over the age of 8 years, by persons with reduced physical, sensory or
mental capabilities and by persons with a lack of experience or knowledge provided that they are supervised and
have been instructed how to use the appliance in a safe way and they understand the hazards involved. Children
must not play with the appliance. Children must not clean or carry out maintenance on the appliance unless they
are being supervised.

GB
6
Installing the fan
Insert the fan in the rectangular opening in the
footplate. The rear edge of the fan must be supported
against the edge of the opening. Check that the rubber
strip on the fan is against the edge of the opening in the
foot plate otherwise noise will occur.
100 mm

GB
7
Installing the control box
The plug and control box are threaded out through the
knockout in the back of the stove. Install the control box
on the wall at a suitable height. Connect the plug only
when the fan is fully installed.
Operating
Connect the plug to the mains.
The fan control box has eight positions.
Mode (0) = The fan is completely switched off.
Mode (1-4 Auto) = Four different speeds for the fan to start
and stop automatically when the stove becomes hot or cold.
Mode (1-3 Man) = The fan is controlled manually with
three speeds.
Automatic control
The fan uses a control module to start and stop the fan
automatically. It functions as follows: The fan starts
when it is approximately time for the first addition of
firewood, this occurs approximately 25 minutes after
the fire is lit (read lighting instructions). When the
fire is dying the fan stops approximately 2 hours after
the fire has turned to embers. The fan uses the heat
that the stove produces and circulates it around the
room efficiently. This means that the fan may stop and
restart a couple of times before it stops completely. If
the stove is already warm and the switch is turned to
“auto” the fan needs a few minutes to sense the heat of
the stove before it starts. The times can vary depending
on the amount and type of wood. For example, dry wood
starts more quickly and a large bed of
embers takes longer to cool. In the event of running
problems the control module can be reset to correct
the problem. This is done by pulling the plug out and
reconnecting it after approximately 15 minutes.
Technical specifications
Power supply: 230V 50Hz Output: 40W
The temperature sensor must only
be attached using cable terminals.
Impacts on the cable sheath are
potentially lethal.
Secure the temperature sensor in the
hole using the screw and nut supplied.
!
In case of not using the fire over
a longer period (e.g. during the
summer) please unplug the fan.
This is to protect the fan’s sensitive
electronics against lightning strike.
!
511957 MAV Fläkt C30 SE/GB-4
2018-09-10