Nibe Contura C500 Style User manual

Installations-
anvisning
Fläkt • Ventilator • Fan • Ventola
C500 Style
C600 Style
Installationsanvisning 2
Installationsanleitung 5
Installation instruction 8
Istruzioni di montaggio 11
SE
DE
GB
IT
contura.eu

GB
8
General
Read through the entire installation instruction before installing
the fan. The fan increases the heating from the stove and makes
the air in the room circulate which gives better heat distribution
and a more even temperature.
Preparations
Unpack and check the contents. For supply air connection from outside,
a distance of 75 mm is required between the condensation insulation
and the hearth base, this is so that there is space for the fan.
!
This appliance may be used by children over the age of 8 years, by persons with reduced physical, sensory or mental
capabilities and by persons with a lack of experience or knowledge provided that they are supervised and have been
instructed how to use the appliance in a safe way and they understand the hazards involved. Children must not
play with the appliance. Children must not clean or carry out maintenance on the appliance unless they are being
supervised.
C500 Style (Before 2019)
C600 Style
C510 Style, C520 Style, C556 Style
C610 Style, C620 Style
C500 Style

GB
9
Tap out the knock out inside the stove leg. Thread the control box and the plug through the rear panels.
Stoves with dampers must not
be equipped with a fan! !!
In case of not using the fire over
a longer period (e.g. during the
summer) please unplug the fan.
This is to protect the fan’s sensitive
electronics against lightning strike.
Installing the fan
Insert the fan in the rectangular opening in the hearth. The
rear edge of the fan must be supported against the edge of
the opening. Check that the rubber strip on the fan is against
the edge of the opening in the foot plate otherwise noise will
occur.
The fan has a 230V power supply, ignoring
the instructions is potentially lethal. The
fan or its components must not be worked
on. Impacts on the cable sheaths are
potentially lethal. If there is a fault in the
fan it must be returned to the place of
purchase.
!
C500 Style
C600 Style
510/ 520S/T/ 556 62 mm
590/ 596 160 mm
610/ 620T 65 mm
690 175 mm

GB
10
Automatic device
The fan uses a control module to start and stop the fan
automatically. It functions as follows:
The fan starts when it is approximately time for the first
addition of firewood, this occurs approximately 25 minutes
after the fire is lit (read lighting instructions). When the fire
is dying the fan stops approximately 2 hours after the fire
has turned to embers. The fan uses the heat that the stove
produces and circulates it around the room efficiently. This
means that the fan may stop and restart a couple of times
before it stops completely. If the stove is already warm and
the switch is turned to “auto” the fan needs a few minutes to
sense the heat of the stove before it starts. The times can
vary depending on the amount and type of wood. For example,
dry wood starts more quickly and a large bed of embers takes
longer to cool.
In the event of running problems the control module can be
reset to correct the problem. This is done by pulling the plug
out and reconnecting it after approximately 15 minutes.
Technical specifications
Power supply: 230V 50Hz Output: 40W
Installing the control box
The plug and control box are threaded out through the
knockout in the rear of the stove. Install the control box on
the wall at a suitable height. Connect the plug only when the
fan is fully installed.
Operating
Connect the plug to the mains.
The fan control box has eight positions.
Mode (0) = The fan is completely switched off.
Mode (1-4 Auto) = Four different speeds when the fan starts
and stops automatically when the stove becomes hot or cold.
Mode (1-3 Man) = The fan is controlled manually with three
speeds.
Remove the inner screw on the plate at the grate control.
Secure the temperature sensor in the hole using the M6X20
screw supplied.
The temperature sensor must only be
attached using cable terminals. Impacts
on the cable sheath are potentially lethal.
!
C500 Style
C500 Style (Before 2019)
C600 Style