Oki 4465871A User guide

4465871A set up manual
4465871A are attached printer base unit according to the following figure.
Function of 4465871A is next page.
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures: -Reorient or relocate the receiving antenna -Increase the separation between the
equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.
4465871A
Toner cartridges and image drum
units set a
r
ea Printer base unit

A toner cartridge and image drum unit are equipped with RF-ID TAG.
If toner cartridges and image drum units are set to a printer, communication of RF-ID TAG and a
RFID read writer module (4465871A) will be attained. The function of this system is the following.
-Management of the existence detection and toner residual quantity of a toner cartridge and image
drum unit
Toner cartridge
RF-ID TAG ×2 Image drum unit