Oki C9600hdn User manual

Finisher Unit Installation Guide
Components
1. Finisher unit
2. Finisher stand
3. Inverter unit
4. Stacking tray
5. Rear cover
6. Clear band
7. Band stopper (2)
Prepare the Printer
1. Turn the printer off and disconnect the power
cord and interface cable.
2. Using a screwdriver, remove the breakout
panels on the side of the printer.
3. Open the face-up stacker.
4. Open the flap and press it onto the stacker
surface
4
2
3
1
5
7
6

2
5. Close the stacker.
6. Install the metal brackets as shown.
Assemble the Finisher
1. Attach the guide rail of the inverter to the
printer with 2 screws.
2. Hook the finisher stand to the inverter.
3. Attach the finisher stand to the inverter with 2
screws.
4. Slip one end of the clear band over the tab on
the right side of the rear cover at a right
angle.

3
5. Slip the other end of the band through the
retainer on the finisher, then secure it with the
smaller stopper.
6. Turn the cover so it faces the finisher.
7. Place the larger stopper over the tab and turn
to lock it in position
8. Attach the rear cover to the finisher and close
it.
9. Loosen the screw on the locking piece so that
it drops through the slot below. This keeps the
platform from moving while you attach the
finisher to it.
10.Position the finisher on the stand and attach
it with two screws from the back.
11.Swivel the locking piece up and tighten the
screw firmly. Be sure it’s out of the way and
the screw is tight—otherwise the platform will
not move freely.

© 2005 Oki Data Americas, Inc. 58372801
12.Position the stacker on the back of the
finisher with the hooks engaged.
13.Make sure the lever on the finisher is
positioned above the stacker.
14.Attach the stacker with four screws.
Complete the Assembly
1. Push the finisher against the printer until the
prongs on the printer brackets fit into the
holes in the finisher.
2. If you need to, turn the levellers on the
finisher to raise or lower the finisher so the
holes and prongs align properly. Make sure the
finisher is level.
3. Connect the printer and the finisher to the
inverter, and connect the inverter’s power
cord.
Leveller