Osram Matchbox Demo User manual

www.osram-os.com
Matchbox Demo User Manual
Intelligent Proximity Sensing
Rolf Weber | August 2013

2
Matchbox Demo Manual
Page
1. Demo Kit Contents 03
2. Getting Started 04
3. Modes 05
4. Software Installation 06
5. Graphical User Interface 12
6. PCB 14

1. Demo Kit Contents
Sensor demo
with Micro USB
jack
3 x AAA
batteries
Battery pack with
Micro USB
connector
USB cable
3

2. Getting Started
Use the battery pack or USB cable to power the demo.
4
1a. Battery Pack
•Insert AAA batteries in the
battery pack
•Connect the battery pack to the
demo
•Switch on battery pack
2. Operating the demo
1b. USB Cable
•Connect the USB cable to
demo and a computer
•See 4. Software Installation
and 5. Graphical User Interface
Indicator LED
layouts and
respective
hand motions

3. Modes
Proximity sensing
(1”, 4” & 6”)
Place hand over
indicator LED at
respective distance for
on. Remove hand for
off.
Slide
Slide finger across the
two indicator LEDs for
on. Slide finger across
in the opposite
direction for off.
Rotary
Rotate finger counter
clockwise around the
three indicator LEDs to
increase brightness.
Rotate finger clockwise
to reduce brightness.
5
Touch
Tap indicator LED to
turn on/off. Hold finger
down to increase/
decrease brightness.
Wave
Wave hand left- right-
left once for on. Wave
a second time for off.
Ambient Light
Sensor
Ambient light will
increase brightness.
The reduction of
ambient light will
decrease brightness.

4. Software Installation
Go to: http://ledlight.osram-os.com/matchboxdemo
6

File name | ORG CODE | Initial
Title/Occasion | MM/DD/YYYY
7
5. Graphical User Interface

5. Graphical User Interface
Proximity sensor parameters:
•Active LED indicator
•Display mode:
•shows all events
•shows events above threshold only

5. Graphical User Interface
Ambient light sensor parameters:
•ALS lower threshold
•ALS upper threshold
•ActualALS readings in counts
•Display mode:
•shows all events
•shows events above upper or below
lower threshold only

5. Graphical User Interface
•Counter of measurements
•Counter limit
•Save data:Active / non active
•Display data:Active / non active
•Data saved in shown excel files
•Data in new file or appended
•Display of measured prox and ALS values