Paradox DGP2-ZX4 User manual

4-Zone Hardwire Expansion Module (DGP2-ZX4)
Instructions
DGP2ZX4-EI01
INTRODUCTION
The DGP2-ZX4 is a 4-zone expansion module that connects
directly to the Digiplex/DigiplexNE control panel. The DGP2-ZX4
provides four additional hardwired input terminals.
INSTALLATION
The DGP2-ZX4 is linked directly to the control panel:
If connecting to a Digiplex (DGP-48)
Connect the DGP2-ZX4’s Expander Connector cable to the
Expansion connector on the control panel as shown in Figure 1.
If connecting to a DigiplexNE (DGP-NE96)
Connect the DGP2-ZX4’s Expander Connector cable to the Zone
Expander connector on the control panel as shown in Figure 1.
ZONEPROGRAMMING
The control panel recognizes the DGP2-ZX4’s inputs as follows:
NO ATZ: Digiplex DigiplexNE
DGP2-ZX4 Input 1 = Input 009 Input 009
DGP2-ZX4 Input 2 = Input 010 Input 010
DGP2-ZX4 Input 3 = Input 011 Input 011
DGP2-ZX4 Input 4 = Input 012 Input 012
ATZ ENABLED: Digiplex DigiplexNE
DGP2-ZX4 Input 1 = Input 009 & 013 Input 009 & 021
DGP2-ZX4 Input 2 = Input 010 & 014 Input 010 & 022
DGP2-ZX4 Input 3 = Input 011 & 015 Input 011 & 023
DGP2-ZX4 Input 4 = Input 012 & 016 Input 012 & 024