Polaris 2879039 User manual

Qty Part Description Part Number
1....... Roof, Canvas
1....... Metal Header Strip
4....... M8 Nylok Nut
4....... Snap
4....... #6 Machine Screws
4....... #6 Nut
4....... M8 Bolt, Allen Head
1....... Instructions 9924226
Qty Part Description Part Number
1....... KIT-SVC,ROOF,HDWR,BESTOP,TTN
(Includes hardware for header
and snaps for rear of roof) 2204809
1....... KIT-SVC,ROOF,HEADER
(Includes front stamped section
of roof and hardware) 2204808
Before you begin, read these instructions twice and check to be sure all parts and tools are accounted for. Please
retain these installation instructions for future reference and parts ordering information.
P/N 2879039
This Kit Includes:
Additional Service Kits Available to Order:
Tools Required:
Socket Torx Wrenches Metric End Wrenches
Phillips Screwdriver
IMPORTANT: For your safety, and to ensure a satisfactory installation, perform all installation steps
correctly in the sequence as shown on the attached instructions. Please wear safety glasses while
performing the steps in the following instructions.
SOFT TOP ROOF KIT
Application
MY 13 Ranger 900 XP
-1-
INSTALLATION INSTRUCTIONS
1. Remove four frame plugs from front of vehicle, two
on each side. Figure 1. Frame Plugs
Front Frame
Figure 1

-2-
3. Install roof top by sliding canvas into the channel in
the metal roof strip. Figures 4 and 5.
Figure 4
Figure 5
Channel
Roof
Slide Roof into Channel in
the Front of Vehicle
Figure 6
4. Install the metal snaps using #6 machine screws
and #6 nylok nuts using metric end wrenches and
a Phillips screwdriver. The holes are located in the
rear-upper frame of the vehicle and correspond to
the snap location on the roof. Figure 6.
Figure 2
2. Removeprotectivelmfromadhesivefoamonmetalheaderstrip.Alignholesinmetalstripwiththeholes
in frame. Install metal strip onto front of vehicle with four bolts using a Allen wrench. Figure 2.
IMPORTANT: If installing roof with a tip out windshield, set the windshield in place on vehicle, install metal
strip then bracket hinge, fasten with bolts and nuts. Figure 3.
Figure 3
Metal Strip
Bolts Bracket Hinge
Snap Installed
Snap Locations

-3-
5. Slide the top hook into the lower part of buckle on B-pillar
upper hinge bracket on each side of vehicle. Tighten the
buckles until roof top is tight. Figure 7.
6. If running the top alone, snap cover into place.
7. If using the rear panel accessory, install Rear Panel kit
according to instructions.
P/N 9924226 Rev 01 07/12
Printed in Mexico
Figure 7
Ranger 900 XP Shown with Soft
Doors, Top and Rear Panel Installed