Polaris 2880056 User manual

IMPORTANT: For your safety, and to ensure a satisfactory installation, perform all installation steps
correctly in the sequence as shown on the attached instructions.
Do not carry sharp or pointed objects.
SPORTSMAN ACE TRAILERABLE
COVER KIT
P/N 2880056
-1-
Application
SPORTSMAN ACE
Kit Contents:
Qty Part Description Part Number
1 Cover 2880056
1 Instructions 9924901
Before you begin, read these instructions and check to be sure all parts and tools are accounted for. Please retain these installation
instructions for future reference and parts ordering information.
APPROXIMATE ASSEMBLY TIME: 5 minutes
INSTALLATION INSTRUCTIONS:
1. If trailering vehicle, make sure vehicle is positioned on the trailer in a forward-facing orientation. Place the
vehicle in ‘‘PARK’’. Turn the key to “OFF” position and remove from the vehicle.
2. Connect the velcro near the ratchet to the velcro on the cover. This will prevent the ratchet from damaging
the unit while installing the cover.
3. Connect the velcro wrap on the inside of the cover to the horizontal bar. Drape the cover over the vehicle.
NOTE: Polaris Star logo should face forward on the vehicle.
4. Pull the bottom edge of the cover down as far as possible all the way around the vehicle.
5. Buckle the bottom webbing together at front of the
vehicle. Figure 1.
Figure 1
Bottom Webbing
Buckle

-2-
P/N 9924901 Rev 01 10/13
7. Operate the ratchet until only a small amount of the
metal wheel is visible. It will create a one-way strap.
Figure 3.
8. Pull the webbing tightly by hand.
9. Adjust the cover by pulling around the bottom.
Ensure cover is tight around the base of the
vehicles tires. Pull the webbing strap by hand
again.
NOTE: Operate the ratchet until webbing is very
snug around the base of the vehicle. Tighten it as
rmly as possible with two ngers only. Ratchet
10. Attach the male buckle of the center strap to the
female buckle sewn to the cover. Feed the webbing
underneath the machine and connect the buckles
on the opposite side. Cinch tight by pulling any
excess slack underneath the foot wells. Figure 4.
11. Cover is equipped to t the optional bumper
system. If the vehicle does not have this accessory,
thread the webbing through the buckles and tighten
to remove extra slack from the cover.
NOTE: These straps are not for attaching the
cover to the vehicle.
Figure 3
Buckle
Figure 4
12. Front and rear openings in the base of the cover allow access to tie the unit down.
13. Retighten the cover after unit is tied down if suspension is compressed.
WARNING
ENSURE THE COVER IS ADEQUATELY TENSIONED PRIOR TO TRAILERING UNIT.
NEVER TRAILER THE COVERED UNIT IN EXCESS OF THE SPEED LIMIT.
DO NOT OVER TENSION COVER.
ONLY TRAILER THE UNIT WITH THE COVER INSTALLED IF THE UNIT IS IN THE FORWARD-FACING
ORIENTATION.
6. Disconnect the ratchet from the velcro on the cover.
At the rear of vehicle, thread the webbing at the
bottom of the cover through the loop of the vertical
hanging strap and thread into ratchet. Figure 2.
Figure 2
Loop of the Vertical
Hanging Strap