Polaris 2881113 User manual

APPLICATION
Verify accessory fitment at Polaris.com.
BEFORE YOU BEGIN
Read these instructions and check to be sure all parts and tools are accounted for.
Please retain these installation instructions for future reference and parts ordering
information.
KIT CONTENTS
This Kit includes:
REF QTY PART DESCRIPTION PART NUMBER
1* 2 Bolt, Shoulder, M8 - 20, M6 X 1.0 -
2* 4 Washer - 6.4 X 18 X 1.4 -
3* 2 Washer, Wave - 8.13 X 12.7 X 0.635 -
4* 2 Washer - 8.40 X 16 X 0.8 -
5 1 Glass Rear Panel - Upper 2635943
6 2 Bracket, Mount 5439918
72 Base, Handle 5451486
8 2 Gasket 5451506
Instr 9926164 Rev 02 11/15 Page 1 of 3
P/N 2881113
GLASS REAR PANEL KIT

Instr 9926164 Rev 02 11/15 Page 2 of 3
REF QTY PART DESCRIPTION PART NUMBER
9 2 Handle 5452442
10 1 Glass Rear Panel - Lower 5452485
11 1 Seal 5522136
12* 4 Torx®Bolt - M6 X 1.0 X 25 7518535
13* 4 Torx®Screw - M6 X 1.0 X 25 7519650
14* 6 Nut, Hex Flange - M6 X 1.0 7547453
15* 5Rivet, Plastic Push - 0.315–0.325 X 0.787 7661855
1 Instructions 9926164
Items marked (*) are included in Hardware Kit PN 2205981.
TOOLS REQUIRED
• Safety Glasses
• Torx®Driver Set
• Drill
• Drill Bit, 5/16 inch
IMPORTANT
Your GLASS REAR PANEL KIT is exclusively designed for your vehicle. Please read the installation instructions
thoroughly before beginning. Installation is easier if the vehicle is clean and free of debris. For your safety, and to
ensure a satisfactory installation, perform all installation steps correctly in the sequence shown.
ASSEMBLY TIME
Approximately 10 minutes
INSTALLATION INSTRUCTIONS
1. Place vehicle in “PARK”. Turn key to “OFF”
position and remove from vehicle.
2. Install Lower Panel
a. Install lower panel aby engaging upper
brackets (A) on lower ROPS as shown.
b. Pivot lower panel ainto ROPS, then install
four screws fthrough panel into ROPS as
shown.

Instr 9926164 Rev 02 11/15 Page 3 of 3
c. Using lower panel aas template, drill five 5/16
inch holes through upper rear close off panel.
Install five plastic push rivets hthrough lower
panel aand upper rear close off panel as
shown.
IMPORTANT
Control drill depth to prevent damage to underlying
structure or components.
3. Install Upper Panel
a. Turn two handles oon upper panel tso they
are in unlocked position (parallel with upper
roof edge) as shown.
b. Install upper panel tby engaging lower
brackets yon lower ROPS as shown. Pivot
panel into ROPS, then turn handles oto
locked position (perpendicular to upper roof
edge) as shown.
NOTE
Tighten bolts qas required to achieve desired level
of handle resistance.