Polaris 2882270 User manual

APPLICATION
Verify accessory fitment at Polaris.com.
BEFORE YOU BEGIN
Read these instructions and check to be sure all parts and tools are accounted for.
Please retain these installation instructions for future reference and parts ordering
information.
KIT CONTENTS
This Kit includes:
REF QTY PART DESCRIPTION PART NUMBER
1 2 Modular Rack Extender -
1 Instructions 9927505
TOOLS REQUIRED
• Safety Glasses
• Torx Driver
• 10mm End Wrench or Socket and Ratchet
IMPORTANT
Your MODULAR RACK EXTENDER KIT is exclusively designed for your vehicle. Please read the installation
instructions thoroughly before beginning. Installation is easier if the vehicle is clean and free of debris. For your
safety, and to ensure a satisfactory installation, perform all installation steps correctly in the sequence shown.
ASSEMBLY TIME
Approximately 10 minutes
Instr 9927505 Rev 01 2016-07 Page 1 of 2
P/N 2882270
MODULAR RACK EXTENDER KIT

Instr 9927505 Rev 01 2016-07 Page 2 of 2
INSTALLATION INSTRUCTIONS
1. Modular rack extender qcan be installed either
on front rack or rear rack of the vehicle.
2. Different locations for modular rack extender q
installation on front and rear rack are shown
below.
Modular Rack Extender on Front Rack
Modular Rack Extender on Rear Rack
NOTE
Below steps reference installation of modular rack
extender qon LH side of front rack. Follow the
same steps for installation on RH side of front rack
and the rear rack.
3. Remove two existing screws (A) from front rack.
Retain screws for modular rack extender
installation.
4. Install modular rack extender qusing screws (A)
on front rack as shown. Tighten screws to
specification.
TORQUE
6 ft. lbs. (8.1 Nm)