Polaris 2881529 User manual

APPLICATION
Verify accessory fitment at Polaris.com.
BEFORE YOU BEGIN
Read these instructions and check to be sure all parts and tools are accounted for.
Please retain these installation instructions for future reference and parts ordering
information.
KIT CONTENTS
This Kit includes:
REF QTY PART DESCRIPTION PART NUMBER
1 1 Frame, Mount -
2 1 Handle 1019949
3 2 Bumper 5412067
4 2 Expansion Anchor Kit, Lock & Ride®2875250
5 2 Washer - 8.4 X 30.0 X 2.0 7556219
1 Instructions 9927735
TOOLS REQUIRED
• Safety Glasses
• Screwdriver, Phillips
• Wrench Set, SAE
Instr 9927735 Rev 01 2016-05 Page 1 of 2
P/N 2881529
TIRE MOUNT KIT

Instr 9927735 Rev 01 2016-05 Page 2 of 2
IMPORTANT
Your Tire Mount Kit is exclusively designed for your vehicle. Please read the installation instructions thoroughly
before beginning. Installation is easier if the vehicle is clean and free of debris. For your safety, and to ensure a
satisfactory installation, perform all installation steps correctly in the sequence shown.
ASSEMBLY TIME
Approximately 5–10 minutes
INSTALLATION INSTRUCTIONS
1. Shift vehicle transmission into “PARK”. Turn key to
“OFF” position and remove from vehicle.
2. Install two bumpers eto mount frame qas
shown.
3. Install two LOCK & RIDE®expansion anchors r
to mount frame qper anchor kit instructions
EXCEPT as follows: Insert washer tbetween
lever and frame as shown.
4. Ensure all expansion anchors rare unlocked,
then install mount frame qinto bed until anchors
are fully seated as shown. Depress levers to lock
in place.
If installation is loose, remove frame from bed,
tighten nut at base of affected anchor(s), and
reinstall.
NOTE
Install on LH side of bed for front or rear wheel/tire
mounting; RH side installation only permits front
wheel/tire mounting.
5. Install spare tire/wheel (sold separately) to mount
frame qusing handle was shown. Three
mounting hole options are provided: use hole
which allows tire to rest on vehicle bed.
NOTE
Cone Acan be reversed as shown to accommodate
different wheel configurations and/or orientation.
TIP
Handle also functions as lug wrench (two sizes).