Polaris 2880290 User manual

P/N 9924821 Rev 02 04/14
Before you begin, read these instructions twice and check to be sure all parts and tools are accounted for. Please
retain these installation instructions for future reference and parts ordering information.
P/N 2880290
SKID PLATE KIT
Application
RZR 900 and RZR 900 S
-1-
2
1
3
Kit Contents:
Ref Qty Part Description Part Number
1 1 HMW Skidplate, Front 5451376
2 1 HMW Skidplate, Mid 5451377
3 1 HMW Skidplate, Rear 5451378
4* 22 Screw, Button Torx M6 X 25 -
5* 20 Washer, Cup For Oversized Hole -
6* 2 J Hook, 1.25” DIA -
7* 2 J Hook, 1.75” DIA -
8* 4 J Hook, 1.00” DIA -
9* 2 Flat Washer -
10* 4 Bracket Clip, M6 Weld Nut -
1 Instructions 9924821
Items marked (*) are included in Hardware Kit PN 2205276.
APPROXIMATE ASSEMBLY TIME: 20-25 minutes
Tools Required:
Safety Goggles Wrench Metric Sockets Set
Torx Driver Ratchet
8

P/N 9924821 Rev 02 04/14
INSTALLATION INSTRUCTIONS:
1. Place the vehicle in “PARK”. Turn the
key to “OFF” position and remove from
the vehicle.
2. Remove the stock skid plate by
removing 6 mm screws and washers at
ten places. Figure 1.
Figure 1
-2-
3. Install the new rear skid plate using
6 mm X 25 screws and washers at four
locations. Figure 2.
NOTE: Torque the screws to 15 ft. lbs.
(20.33 Nm).
Figure 2
IMPORTANT: Your Polaris SKID PLATE KIT is exclusively designed for your vehicle. Please read the
installation instructions thoroughly before beginning. Installation is easier if the vehicle is clean and
free of debris. For your safety and to ensure a satisfactory installation, perform all installation steps
correctly and in the sequence shown.
Screw
Screw
Rear Skid Plate

P/N 9924821 Rev 02 04/14 -3-
4. Insert bracket clip on chassis bracket at
four locations as shown in Figure 3.
5. Install the new mid skid plate using
6 mm X 25 screws and washers at
seven locations. Figure 4.
NOTE: Torque the screws to 15 ft. lbs.
(20.33 Nm).
Figure 3
Figure 4
Mid Skid Plate
Bracket
6. Installation of front skid plate:-
a. Loosely install the hooks to the front
skid plate using 6 mm screws and
washers at six locations.
IMPORTANT: Install J hook
(1.75” dia.) at two locations and the
J hook (1.00” dia.) at rest of four
locations.
IMPORTANT: Install screw M6x25 at
two locations.
b. Tighten front skid plate to chassis
using 6 mm screws and washers at
13 locations as shown in the
Figure 5.
NOTE: Torque the screws to
15 ft. lbs. (20.33 Nm).
Figure 5
Washer
Hook
Hook 1.75” Dia.
Screw
M6X25
Screw
Hook
1.00” Dia.