Polycom VVX 150 Manual

Polycom®VVX®150 and VVX®250
Business IP Phones
Setup Sheet
VVX 150 VVX 250
Package Contents
VVX 150 or VVX 250 Base Stand Handset
Handset Cord Network Cable Setup Sheet
Optional Accesories
AC power adapter
(varies by region) Wall Mount Bracket
For more information on optional accessories, contact your reseller.

Features
Connect Cables
Note: Only use the power supply designed for your phone to avoid
damaging the phone.

Connect Stand
Desktop
Wallmount
Connect Optional Headset
Note: Your phone supports
USB and wired headsets,
including Electronic Hookswitch
(EHS) headsets.
For connection directions, refer
to your headset documentation.
Standard headsets typically use
the RJ-9 or USB port while EHS
headsets use the RJ-9 and
EHS ports.

BY USING THIS PRODUCT, YOU ARE AGREEING TO THE TERMS OF THE END USER LICENSE AGREEMENT (EULA) AT:
http://documents.polycom.com/indexes/licenses. IF YOU DO NOT AGREE TO THE TERMS OF THE EULA, DO NOT USE THE
PRODUCT, AND YOU MAY RETURN IT IN THE ORIGINAL PACKAGING TO THE SELLER FROM WHOM YOU PURCHASED THE
PRODUCT.
The Terms and Conditions applicable to Polycom’s Limited Warranty for this product are found at
http://supportdocs.polycom.com/PolycomService/support/global/documents/support/others/plcm_warranty_summary.pdf
SAFETY AND REGULATORY INFORMATION.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This
device must accept any interferences received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
The VVX 150 and VVX 250 are marked with the CE mark. This
mark indicates compliance with LVD and EMC Directives
2014/35/EC and 2014/30/EC.
In accordance with Part 15 of the FCC Rules, the user is cautioned
that any changes or modifications not expressly approved by
Polycom, Inc. could void the user’s authority to operate the
equipment.
Regulatory Notice:
https://support.polycom.com/content/dam/polycom-support/prod-
ucts/voice/business-ip-phones/other-dcouments/en/vvx-ip-regulat
ory-notice.pdf
Operating Ambient Conditions:
• Operating temperature: +32 to 104°F (0 to 40°C)
• Relative humidity: 5% to 95%, non-condensing
• Storage temperature: -40 to +160°F (-40 to +70°C)
Installation must be performed in accordance with all relevant
national wiring rules.
L’Installation doit être exécutée conformément à tous les
règlements nationaux applicable au filage électrique.
The outlet to which this apparatus is connected must be installed
near the equipment and must always be readily accessible.
La prise électrique à laquelle l’appareil est branché doit être
installée près de l’équipement et doit toujours être facilement
accessible.
When using Power over Ethernet (PoE), the equipment is to be
connected only to PoE networks without connections to the
outside plant.
Lorsque vous utilisez une alimentation électrique par cable
ethernet (PoE - Power over Ethernet), l'équipement doit être
connecté uniquement aux réseaux PoE sans connexions vers
l'extérieur de l'usine.
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] sera conforme à la norme
NMB-003 du Canada.
To avoid electric shock, do not connect safety extra low voltage
(SELV) circuits to teleconference station network (TNV) circuits.
LAN ports contain SELV circuit, and WAN ports contain TNV
circuits. Some LAN and WAN ports both use RJ-45 connectors.
Use caution when connecting cables. This product is rated 5Vdc,
3A. When used with the optional external power supply
(MSP-C3000IC5.0-18A-US, MSA-C3000IC5.0-18P, or similar rated
PSU), the power supply shall be a Listed power supply with a LPS
output, rated 5V, min. 3A.
Afin d'éviter les chocs électriques, ne pas connecter de circuits
de tension extra-basse de sécurité (SELV) à des circuits de réseau
de stations de téléconférence (TNV). Les ports LAN contiennent
un circuit SELV et les ports WAN contiennent des circuits TNV.
Certains ports LAN et WAN utilisent tous deux des connecteurs
RJ-45. Faites preuve de prudence lors de la connexion des
câbles. Ce produit a les caractéristiques suivantes : 5 Vdc, 3 A.
Lorsqu'il est utilisé avec le bloc d'alimentation externe facultatif,
(MSP-C3000IC5.0-18A-US, MSA-C3000IC5.0-18P, ou une
alimenation semblable), l'alimentation électrique doit être
répertoriée et munie d'une sortie LPS, possédant les
caractéristiques suivantes : 5 V, 3 A min.
In addition, all PoE sources must meet the Limited Power Source
requirements of IEC 60950-1:2005 (2nd Edition); Am1:2009 or IEC
60950-1:2005 (2nd Edition); Am1:2009; Am2:2013.
En outre, toutes les sources PoE doivent satisfaire aux exigences
de source d'alimentation limitée de la IEC 60950-1:2005 (2ème
édition); Am1:2009 ou IEC 60950-1:2005 (2ème édition);
Am1:2009; Am2:2013.
Hearing Aid Compatibility (HAC):
This device is hearing aid compatible. This product meets the
applicable Innovation, Science and Economic Development
Canada technical specifications.
RoHS: All Polycom phones comply with the requirements of the
EU RoHS Directive. Statements of compliance can be obtained
from T[email protected]
Australia:
Warning—This equipment will be inoperable when mains power
fails.
Japan:
1725-48815-001E