Prevue Hendryx 58500 User manual

*
*
58500 — 06/22 — A4 Made in China for Prevue Pet Products, Inc., 224 N Maplewood Ave, Chicago IL 60612 USA • 1 [312] 243-3624 • www.prevuepet.com • customerservice @ prevuepet.com
HARDWARE :
KEY:
L = Left Side B = Back
= ight Side F = Front
CM = Center/ MidLevel Floor
Ferret Stack | Add-On Set
PARTS LIST
Instructions online at www.prevuepet.com
]L
]Cm
]B
]F
]R
Hex Screws • 10 pcs
Hex Key
CUSTOMER SUPPORT
Please contact Prevue Pet Products:
PHONE [phone]
ONLINE www.prevuepet.com
EMAIL customerservice @ prevuepet.com
These pieces are
interchangeable:
]L= ]R
⁕
ADD-ON SET: WHAT IT IS / WHERE TO ADD IT
The Add-On Set is essentially an entire floor
unit, complete with a platform and ramps.
The floor unit can be added at any of the
locations indicated by the ( ) symbol on
the diagrams below.
Our recommended insertion point for the
Add-On Set is indicated by the ( *).
Adding the extra floor under the top-most
unit will be easiest for assembly.
IMPO TANT NOTE:
If you are adding an additional floor to the
3-Story (#58503) model, you will need the
help of an assistant.
Any Ferret Stack over three floors will need
to be anchored to the wall for stability.
58500
MODEL
#
PLATFORM
RAMPS
An isolated view of the
assembled unit
58501
MODEL #
58500
MODEL #
58502
MODEL #
58503
MODEL #

For more wonderful cages, toys, and accessories for cats, irds, chickens, ra its, ferrets, dogs and small animals, visit www.prevuepet.com
× 10
1PIECES
]L
]R
]F]Cm
]B
interchangeable
Ferret Stack | Add-On Set
ASSEMBLY
Instructions online at www.prevuepet.com
CUSTOMER SUPPORT
Please contact Prevue Pet Products:
PHONE [phone]
ONLINE www.prevuepet.com
EMAIL customerservice @ prevuepet.com
58500 — 06/22 — A4
58500
MODEL
#
PLATFORM
RAMPS
At the lower-corner bracket:
• EMOVE the top-hole screws
• LOOSEN the bottom-hole screws
You may want to take out the platform & ramp.
• EMOVE the entire top floor unit.
• eserve the four screws for re-attachment.
• Stand the ADD-ON left side and front
panels in position and hand-tighten hex
screws in the bottom hole of the top
bracket and the open hole at the base.
• Continue adding and attaching the
ack and right side panels with hand-
tightened hex screws.
• Place the ADD-ON mid-level floor
panel in position and attach with a
hand-tightened hex screw, one at
each end.
• EPLACE the top unit onto the
ADD-ON floor addition.
• Attach the top floor unit with the four
screws reserved at the beginning.
•T ghten ALL screws w th the hex key
unt l snug.
• eplace platforms and ramps.
Assembly completed. {
reserve the
screws and
top unit
until end