Prevue Hendryx Hamster Haven User manual

CUSTOMER SUPPORT
For assistance or replacement parts,
please contact Prevue Pet Products:
PHONE [phone]
ONLINE www.prevuepet.com
EMAIL cus omerservice @ prevuepe .com
2005—03/20—A4 Ma e in China for Prevue Pet Pro ucts, Inc., 224 N Maplewoo Ave, Chicago IL 60612 USA • 1 [312] 243-3624 • www.prevuepet.com • customerservice @ prevuepet.com
Instructions online at www.prevuepet.com
1PIECES
2PIECES
Starting from the bottom, pull the extended
hooked wires of the side panel onto the back panel.
The middle wire hooks under the corresponding
horizontal wire on the back panel.
Link one complete seam together, then use the
same method on the other seam to finish.
Set the assembled mesh into the base and attach
with the clips. Hook the base clips onto the short
horizontal wire on the side panel, and then clip it
onto the base by pushing down until it “clicks”.
DETAIL OF INSIDE BACK, LEFT CORNER
2005 Hamster Haven/large
ASSEMBLY
MODEL #

2005—03/20—A4 For more won erful cages, toys, an accessories for cats, bir s, chickens, rabbits, ferrets, ogs an small animals, visit www.prevuepet.com
*CLEANING INSTR CTIONS
To prolong the life of your new
Prevue Pet Products cage, we recommend:
→When cleaning the cage and parts, use a
soft cloth or non-abrasive scrub pad (such
as Prevue’s Cage Saver (#109)).
→Wash all parts with warm water and a mild
environmentally friendly, pet-safe soap.
→Rinse thoroughly.
→Hand dry all parts completely with a soft dry
cotton cloth before reassembling the cage.
→Do not leave plastic parts in the sun to dry
as they may warp.
3PIECES
4PIECES
Assemble the platform components by
adding the slide, then centering the hideaway
dome over the raised circle and rotating
it into place with a “click”. Install the platform into the cage.
Assembly completed. {
Position the wheel close
to the base floor. Insert
the handle on the back
of the wheel through the
cage wires.
Rotate the handle 90° to
secure the wheel.
Catch the central
portion of the rooftop
on the tabs along the
front and back panels.
Finish with catching
the roof end panels
on the tabs along the
side panels.
NOTE: Roof end
panels are doors,
hinged along the
inner seams, to
offer rooftop cage
access.
SNAP THE
TRANSLUCENT
WHEEL COVER
ONTO THE BACK