Prevue Hendryx 485 User manual

Feisty Ferret
Home
Model: # 485 (A)
read first REVIEW BEFORE ASSEMBLY
• TOOLS: Allen wrench (included).
Have needle nose pliers (not included)
on hand. If using power tools, be
careful not to over-tighten screws.
For assistance or replace ent parts,
please contact Prevue Pet Products:
TOLL-FREE 800.243.3624
ONLINE www.prevuepet.co
EMAIL [e-mail]
485 (A)—07/15—USL Made in China for Prevue Pet Products, Inc., Chi ago IL USA www.prevuepet. om 800 243-3624 ustomerservi e@prevuepet. om
1To assemble the BASE, you
will need these pieces:
2To assemble the first level
CAGE FRONT & BACK,
you will need these pieces:
3To assemble the first level
CAGE FLOOR & SIDES,
you will need these pieces:
× 4 (long)
× 4
Attach the storage shelf to the leg frames with
one long screw in each corner. Note: the
windbell loc on the front leg frame faces out.
Flip unit over and fully insert
casters into frame legs.
× 4 (long)
Guide the lower level front panel (with door)
and bac panel into the leg frames as illustrated.
Note: the lower panels have openings at the
top corners.
× 4 (long)
Slide the lower level side panels into place.
Note: the trac that will hold the mid-level
floor is at the top and facing in.
Secure the panels with one
long screw in each
bottom corner.
Slide the first floor panel
down into place.
Attach the grille/tray trac frames. Secure the
trac s in place with one long screw in each
corner (lower hole). Note: the trac
orientation is with the open end
facing the front.

× 2
× 3
485 (A)—07/15—USL Made in China for Prevue Pet Products, Inc., Chi ago IL USA www.prevuepet. om 800 243-3624 ustomerservi e@prevuepet. om
4To assemble the second level
CAGE FRONT & BACK,
you will need these pieces:
5To assemble the second level
FLOOR & SIDES, you will need
these pieces:
7Finish the assembly with the
ROOF, HAMMOCK & TRAY.
You will need these pieces:
6To install the PLATFORMS &
RAMPS, you will need these
pieces:
× 4 (long)
Slide the upper level front and bac panels into
place and secure with one long screw in each corner.
Note: each corner screw will secure the intersection
of three panels.
× 2 (short)
× 8 (long)
Slide the mid-level floor (with the
removable hatch door) down into place.
Secure the floor in place with a short
screw in the center of each side.
Slide the upper level side panels into
place and secure with a long screw in
all top and bottom corners.
× 2 (short)
Set the roof panel (with the sliding door)
into place and secure it into place with
a short screw in the center of each side.
Add the hammoc into either level.
Rotate the windbell loc out of the way
and slide the debris tray into place.
Your cage is assembled and ready for use!
6.1 Remove the hatch door cover. 6.3 Clip a platform/ramp
set onto the cage in the
lower level.
6.4 Clip the leftover ramp
onto the floor at the
hatch opening and rest
the lower end onto the
platform.
6.2 Snap the ramps onto the underside of the
platforms (as illustrated) to ma e two
platform/ramp sets.