Prevue Hendryx Hamster Haven User manual

CUSTOMER SUPPORT
For assistance or replacement parts,
please contact Prevue Pet Products:
PHONE [phone]
ONLINE www.prevuepet.com
EMAIL cus omerservice @ prevuepe .com
2003+98005 — 03 /20— A4 M de in Chin for Prevue Pet Products, Inc., 224 N M plewood Ave, Chic go IL 60612 USA • 1 [312] 243-3624 • www.prevuepet.com • customerservice @ prevuepet.com
98005
Instructions online at www.prevuepet.com
MODEL # Hamster Haven/small
ASSEMBLY
1PIECES
2PIECES
Starting from the bottom, pull the extended hooked
wires of the side panel onto the back panel. The
middle wire hooks under the corresponding horizontal
wire on the back panel.
Link one complete seam together, then finish with the
remaining seam.
Set the assembled mesh into the base and
attach with the clips. Hook the base clips
onto the horizontal wire and clip it onto the
base by pushing down until it “clicks”.
2003
MODEL #
DETAIL OF INSIDE BACK, LEFT CORNER

2003+98005 — 03 /20— A4 For more wonderful c ges, toys, nd ccessories for c ts, birds, chickens, r bbits, ferrets, dogs nd sm ll nim ls, visit www.prevuepet.com
*CLEANING INSTR CTIONS
To prolong the life of your new
Prevue Pet Products cage, we recommend:
→When cleaning the cage and parts, use a
soft cloth or non-abrasive scrub pad (such
as Prevue’s Cage Saver (#109)).
→Wash all parts with warm water and a mild
environmentally friendly, pet-safe soap.
→Rinse thoroughly.
→Hand dry all parts completely with a soft dry
cotton cloth before reassembling the cage.
→Do not leave plastic parts in the sun to dry
as they may warp.
3PIECES
4PIECES
First, install the lower
platform (without the
hideaway dome). Add a
slide into the hole on the
platform.
To the upper platform, add
the slide, then center the
hideaway dome over the
raised circle and rotate it
into place with a “click”.
Install the second platform
into the cage.
Assembly completed. {
Position the wheel close
to the base floor. Insert
the handle on the back
of the wheel through the
cage wires.
Rotate the handle 90° to
secure the wheel.
Catch the center of
the rooftop on the tabs
at the front and back.
Finish with catching
the roof ends on the
tabs along the side
panels.
The end with the
extended handle loops
is hinged along the
center seam, and
offers rooftop cage
access.
SNAP THE
TRANSLUCENT
WHEEL COVER
ONTO THE BACK