real living GBO-XG-204 User manual

OAKS LANDING STEEL PARK BENCH WITH CAST IRON BACK
ASSEMBLY INSTRUCTIONS
ITEM# : GBO-XG-204
SKU# : 810587611
Need help? We are here for you! 1-888-733-8169 Toll Free
Or email us at [e-mail],[email protected]
[email protected]

GENERAL BEST PRACTICES FOR ASSEMBLY:
Read all instructions before starting
Clear a flat covered space to begin assembly
Always best to do it with a friend
Note that hardware required is provided for every step
Pay attention to orientation
Number of the hardware corresponds to its letter in the package
Helpful hints provided along the way
WARNINGS:
Use the correct screws as indicated. All screws should be hand tightened until the complete piece is
assembled ( This will make the assembly process much easier ). Once the piece is fully assembled, then go
back and tighten all screws with provided tool.
Keep all children and pets away from assembly area. Children and pets should be supervised when they are in the area of the
product construction.
Keep assembly area at least 6 feet from any obstruction such as a fence, garage, house, overhanging branches, laundry line or
electrical wires.
Some parts may contain sharp edges. When assembling and using this product, basic safety precautions should always be followed
to reduce the risk of personal injury and damage to the product. Please read all instructions before assembly and use.
The bench is not to be used for standing purposes and will not function as a stool or step-ladder. Use on even surfaces only.
The bench is used at weight of 450lb (204.5kg). Improper use of this product or failure to use as directed
may result in injury. Not intended for commercial use.
MAINTENANCE
Before using, clean the product completely with a soft dry towel. When not in use, wipe free of any dirt or loose objects. Wash with a
mild solution of soap and water, rinse thoroughly and dry completely. Do not use strong detergent or abrasive cleaners. Screws may
loosen over time, please check the screws occasionally and re-tighten if necessary.

PARTS LIST
A
B
C
2PC Arms 1PC Bench Seat Panel 1PC Bench Back Panel
HARDWARE LIST
D
E
F
4PC Short Screw (M6x50mm) 4PC Long Screw (M6x70mm) 8PC Washer
G
I
J
8PC Nut 1PC Allen Wrench 1PC Open End Wrench
H
4PC Plastic Cover
Warranty
One year limited warranty.
Proof of purchase (dated register receipt) is required for warranty claims.
It remains the customer's responsibility for freight and packing charges to and from the service center.

STEP 1
Secure bench seat Panel (B) to 2 bench arms (A) with 4
short screw (D), 4 washer (F) , 4 nut (G) and 4 plastic
cover (H) by using allen wrench (I) and open end
wrench (J). Do not fully tighten all screws now.
STEP 2
Secure bench back panel (C) to 2 bench arms (A) with 4
long screw (E), 4 washer (F) and 4 nut (G) by using
allen wrench (I) and wrench (J).
Adjust and tighten all screws. Finish!
B
C
D
I
F
G
H
J
I
J
G
E
F
A
A
A
A