real living GB-XG-222 User manual

STEEL LATTICE BENCH WITH CAST IRON BACK
ASSEMBLY INSTRUCTIONS
ITEM# GB-XG-222
SKU# 810588203
DO NOT RETURN THIS PRODUCT TO THE STORE. FOR MISSING PARTS OR QUESTIONS TO THIS PRODUCT PLEASE CALL US AT 1-888-733-8169
OR EMAIL US AT customerservice[email protected]et OR customerservice_0[email protected] OR [e-mail]
IMPORTANT:
Please read all the instructions and warnings before assembling.
Please install all the screws on the product before fully tightened, and note to put the washer to the screw before putting the screw into the screw hole.
WARNING:
● Use the correct screws as indicated. All screws should be hand tightened until the complete piece is assembled ( This will make the
assembly process much easier ). Once the piece is fully assembled, then go back and tighten all screws with provided tool.
● Keep all children and pets away from assembly area. Children and pets should be supervised when they are in the area of the product construction.
● Keep assembly area at least 6 feet from any obstruction such as a fence, garage, house, overhanging branches, laundry line or electrical wires.
● Some parts may contain sharp edges. When assembling and using this product, basic safety precautions should always be followed to reduce the risk of personal
injury and damage to the product. Please read all instructions before assembly and use.
● The bench is for sitting purpose only. It is not to be used for standing purposes and will not function as a stool or step-ladder. Use on even surfaces only.
● The bench is not a toy. Bench tested for use at weight of 450 lb (204.5 kg). Improper use of this product or failure to use as directed
may result in injury. Not intended for commercial use.
CARE & MAINTENANCE
● Before using, clean the product completely with a soft dry towel. When not in use, wipe free of any dirt or loose objects, wash with a mild solution of soap and
water, rinse thoroughly and dry completely. Do not use strong detergent or abrasive cleaners. Screws can be loosen over a period of usage, please check the screws
occasionally and re-tighten if necessary.

PARTS LIST
NO. Part Qty Image NO. Part Qty Image
ABench Arm 2FWasher 8
BBench Seat Panel 1GNut 4
CBench Back Panel 1HPlastic Cover 4
DShort Screw
(M6x50mm) 4IAllen Wrench 1
ELong Screw
(M6x55mm) 4JOpen End Wrench 1
STEP 1
Secure bench seat Panel (B) to 2 bench arms (A) with 4 short screw (D), 4 washer (F) , 4 nut (G) and 4 plastic cover (H) by using allen wrench
(I) and open end wrench (J). Do not fully tighten all screws now.
STEP 2
Secure bench back panel (C) to 2 bench arms (A) with 4 long screw (E), 4 washer (F) by using allen wrench (I) and wrench (J). Adjust and
tighten all screws. Finish!
Warranty
One year limited warranty.
Proof of purchase (dated register receipt) is required for warranty claims.
It remains the customer's responsibility for freight and packing charges to and from the service center.
B
A
C
A
I
J
A
A
I
J
D
F
G
H
F
E