Resolution RE319 User manual

RE319_DSC_Flood_Temp_Instructions Page 1 of 4 7-Jan-15
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
RE319 Flood/Temp Range, DSC
®
-Compatible
Home Disaster™ Sensor
Features
• Tri-Mode Environmental Sensing:
o Flood/Moisture Sensor
o Freeze – for Furnace Failure
o verheat – for Furnace runaway or Air Conditioning failure.
• 3 unique wireless IDs or Loops: one for each function
• Cover tamper.
• Strong, reliable RF signal.
• 8-10 year battery life on CR123A battery.
• Low Battery indication.
• 3.3x1.4x1.1 inches.
Key Instructions
• Battery “+” faces towards spring.
• Activating Zones
 Flood Zone operates on unit when it comes from the factory. The
enrolling actions (listed next) activate the Freeze and verheat Zones.
 ACTIVATE NLY THE Z NES Y U NEED
(In order to extend battery life and prevent RF pollution):
• Enrolling: Place control panel in enroll mode… then for…
 Flood - Zone 0: ESN ends in “0” (this ESN is printed on sensor):
 Enroll by:
• …Shorting and opening Flood Sensor
 Sensor sends Flood Alarm & enrolls.
 Freeze - Zone 1: ESN ends in “1”:
 Enroll by:
• Holding Tamper down,
• Leaving magnet away from Reed Switch,
• …while installing battery.
 Sensor sends Freeze-Alarm & enrolls.
 verheat – Zone 2: ESN ends in “2”:
 Enroll by:
• Holding Tamper down,
• Having magnet next to Reed Switch,
• …while installing battery.
 Sensor sends verheat Alarm & enrolls.
RE319_DSC_Flood_Temp_Instructions Page of 4 7-Jan-15
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
Operation
• Flood (ESN ending in 0)
Alarm: when liquid rises 0.040 inches above sensor bottom.
Tamper: when cover is opened.
Supervisory: every hour.
• Freeze (ESN ending in 1)
Alarm: when room temperature drops below 40F.
Tamper: when cover is opened.
Supervisory: every hour.
• verheat (ESN ending in 2)
Alarm: when room temperature rises above 100F.
Tamper: when cover is opened.
Supervisory: every hour.

RE319_DSC_Flood_Temp_Instructions Page 3 of 4 7-Jan-15
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
Specifications
Flood sensing: Titanium contacts
100K- hm nominal (D N T use an E L resistor)
Transmitter handles 1 or 2 flood elements, no more.
0.04 inch floor spacing to eliminate floor
condensation falses.
Checks for moisture every 5 seconds: needs two
positive moisture checks to send Flood alarm.
(test mode: every second when cover is off)
Freeze Alarm: 45F +/- 2F
Restores when temp increases 4F from alarm
verheat Alarm Temp: 100F +/- 2F
Restores when temp decreases 4F from alarm
Mounting hardware: #6 or #8 screws
Dual Mode mounting:
 Screwed to floor
 Screwed to wall
Terminal wire capacity: 16 Gauge
Replacement Battery: CR123A 1550 mAH
Temperature Range: 0F to 120F
Housing dimensions: 3.3x1.4x1.1 inches
Specifications subject to change without notice.
Internal & Close-up Pictures
Temp Element
Strain relief for
floor mounting
RE319_DSC_Flood_Temp_Instructions Page 4 of 4 7-Jan-15
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
Notices
“GE”, “Honeywell”, and “DSC” are trademarks owned by General Electric Company, Honeywell
International Inc., and Tyco Safety Products Canada LTD, respectively.
Resolution Products, Inc. products will function with one of either GE, DSC or Honeywell systems.
However, no Resolution product is produced by, endorsed by, nor is officially associated with GE,
Honeywell or DSC. Resolution recommends verifying proper enrollment and operation, per control
panel installation instructions, at installation.
Warranty
Resolution Products, Inc. will replace products that are defective in their first five (5) years.
FCC Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
This device may not cause harmful interference.
This device must accept any interference that may be received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the Resolution Products, Inc. could void
the user's authority to operate this equipment.
FCC ID: U5X-RE301
IC Notice
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1)This device may not cause interference, and
( )This device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1)l'appareil ne doit pas produire de brouillage, et
( )l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
IC: 8310A-RE301