Resolution CryptiX RE601 User manual

RE601_Cryptix-Compat_DWS_Instructions
24-Hour Tech Support Line: [phone] 26-Feb-15
www.ResolutionProducts.com
Installation Guide
RE601 CryptiX ™ -Compatible Standard Door / Window
Features
• For sensing things that open or separate
• Strong, reliable RF signal
• 10-15 year battery life
• over tamper
• Low Battery indication
• 3 total zones
• Main reed switch + magnet
• 2 Optional External ontacts
Enrollment
• Place panel in enrollment mode.
• Sensor enrollment signal can be sent by one of these two ways.
• Remove the battery tab.
• Pull cover off to tamper device.
• To set up zone and configure the sensor, log into the web based dealer portal
Installation
• Place sensor on a door or window using the mounting holes.
• Below are recommendations for sensor locations.
Mounting
holes
RE601_Cryptix-Compat_DWS_Instructions
24-Hour Tech Support Line: [phone] 26-Feb-15
www.ResolutionProducts.com
• Mount the sensor with magnet on the side of the sensor with the mark as
pictured below.
Optional External Contact Mounting and Wiring
• Optional External contact wiring.
• External Input #1: Outer Terminal Zone + enter ommon Terminal
• External Input #2: Inner Terminal Zone + enter ommon Terminal
• Optional external contact zones are: normally closed – alarm on open.
• No end-of-line resistors on external contact zones.
Note: External contacts not evaluated by ETL
Outer Terminal Zone
External Input #1
enter ommon Terminal
Inner Terminal Zone
External Input #2
Magnet rests in
drilled hole on
top of door.
E
xternal
contact is
wired to the door
window sensor
through a hole
drilled in the
doorframe
Magnet Mark

RE601_Cryptix-Compat_DWS_Instructions
24-Hour Tech Support Line: [phone] 26-Feb-15
www.ResolutionProducts.com
Operation
• Reed switch or optional external contact
Alarm, when…
…magnet is pulled away from reed switch or
…external contact is opened
Tamper, when cover is opened
Supervisories, every hour
Specifications
Specifications subject to change without notice.
RE601_Cryptix-Compat_DWS_Instructions
24-Hour Tech Support Line: [phone] 26-Feb-15
www.ResolutionProducts.com
Notices
Warranty
Resolution Products, Inc. will replace products that are defective in their first five (5) years.
FCC Notice
his device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
his device may not cause harmful interference.
his device must accept any interference that may be received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by the Resolution Products, Inc. could void the
user's authority to operate this equipment.
FCC ID: U5X-RE301
IC Notice
his device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) his device may not cause interference, and
(2) his device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1)l'appareil ne doit pas produire de brouillage, et
(2)l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
IC: 8310A-RE301
Manual: 47-0004-08 REV A