Resolution 2GIG Compatible Trident RE218T User manual

Trident is an integrated environmental sensor. It detects ood
conditions and reports extreme temperatures.
Features
• Titanium probes for unmatched corrosion immunity
• IP67 rated waterproof enclosure
• GORE
®
vent to prevent seal failure
• 5 year warranty
Enroll by placing the panel into wireless enrollment mode and
removing the battery tabs, tampering the sensor, or manually
entering the sensor ID. NOTE, Trident requires rmware
version 1.14 or later for GC2 Panel and 3.1 or later for
CG3. For older panel rmware versions, use the RE218
Honeywell
®
Compatible Trident.
Panel Questions Flood Heat Freeze
Sensor Type [08] 24 Hour
Aux. Alarm
[08] 24 Hour
Aux. Alarm
[08] 24 Hour
Aux. Alarm
Equipment Type [8] Water [10] Temp. [6] Freeze
Equipment Code [1065] 2GIG
Flood Sensor
[1065] 2GIG
Flood Sensor
[1065] 2GIG
Flood Sensor
Sensor Age [0] New [0] New [0] New
Loop Number [1] Flood [2] Heat [3] Freeze
Install by placing the sensor in the location requiring ood or
temperature detection. If desired, the wall clip can be used
to secure the Trident sensor.
Optional Screw Mounting
• Remove the wall clip from the Trident body.
• Secure the clip to a wall, baseboard or cupboard
using a #6 screw.
• Slide the Trident body down onto the wall clip until
it snaps into place.
Trident detects water pooled under the sensor and reports
extreme temperature conditions.
Temperature Trip Points
• Heat alarms when over 100°F (38°C)
• Heat restores when under 97°F (36°C)
• Freeze alarms when under 45°F (7°C)
• Freeze restores when over 48°F (9°C)
To replace the batteries, insert a at blade screwdriver into
the front slot and twist. Slide both old batteries out and the
new batteries in. To reinstall the cover, align the rear latches
and roll the cover forward until it snaps into place.
I
N
S
T
A
L
L
G
U
I
D
E
I
Verify proper enrollment and operation using your control panel’s installation manual.
RE218T 2GIG® Compatible Trident™Environmental Sensor
Front slot
Mounting Screw Hole
Wall Clip

47-0028-05 • RevA • 2016-11-10
Tech Support Line [phone]
www.ResolutionProducts.com
WARRANTY
Resolution Products, Inc. will replace products that are defective in
their rst ve (5) years.
IC NOTICE
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux cnr d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes:
(1) L’appareil ne doit pas produire de brouillage, et
(2) L’utilisateur de l’appareil doit accepter tout brouillage ra-
dioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
IC: 8310A-RE218
FCC NOTICE
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may be received,
including interference that may cause undesired operation.
Changes or modications not expressly approved by the Resolu-
tion Products, Inc. could void the user’s authority to operate this
equipment.
FCC ID: U5X-RE218
TRADEMARKS
“2GIG” and “Honeywell” are trademarks owned by Nortek Security &
Control LLC and Honeywell International Inc. respectively.
Resolution Products, Inc. products will function with 2GIG and
Honeywell systems. However, no Resolution product is produced by,
endorsed by, or is ofcially associated with Nortek or Honeywell.
Resolution recommends verifying proper enrollment and operation,
per control panel installation instructions, at installation.
Pro Tips
The cover can be removed without removing the wall clip.
Both titanium probes must be in the same puddle for the Trident to detect water.
Tamper detection depends on how the Trident is installed.
• Trident secured to wall: Tamper is indicated when lifted off the clip.
• Trident NOT secured to wall: Tamper is indicated when the cover is removed.
When changing the batteries replace both with new batteries.
Automatic enrollment signals are sent for loop 1 (Flood) when the battery tabs are
removed.
Specications
Physical
Housing Dimensions
Weight with Batteries
Mounting Fastener
2.43 x 2.48 x 1.17 inches (6.2 x 6.3 x 3.0 cm)
1.34 ounces (38 grams)
#6 screw (not provided)
Environmental
Operating Temperature
Maximum Humidity
Water Resistance
32°F to 120°F (0°C to 49°C)
85% non-condensing relative humidity
IP67 rated (Waterproof for over 30 minutes at 1 meter depth)
Sensor Specications
Frequency
Replacement Batteries
Nominal Battery Life
Battery Voltage
Current Draw
Transmitted Indications
Temperature Accuracy
345 MHz
Two Panasonic CR2032
10 years
3.0 VDC (Nominal) 2.3 VDC (Low)
20 mA (Maximum) 0.5 uA (Quiescent)
Cover Tamper, Wall Tamper, Low Battery, Supervision
+/- 2°C
Certication
RE218T FCC, IC
Specications subject to change without notice.