Ricoh BN3110 Quick start guide

1 Bin Tray BN3110
Machine Code: D692
Field Service Manual
July, 2014
Subject to change

Revision Lists
Version Details
1.00 - Initial release of this document
Created this manual for D76/D177 series.
1.10 All Revised all sections according to the release of
D197 series
Modified some parts name.
Read This First > Safety and
Symbols Revised some icons.
Replacement and Adjustment >
Paper Sensor
• Added a Note and some items need to be
removed in Step 2.
•Changed some picture for Step 2.
• Changed the picture for Step 4.
• Added the items need to be removed in
Step 5.
• Added a picture for Step 5.
• Modified the Step 6 and Note.
• Added some items need to be removed in
Step 9.
Replacement and Adjustment >
Controller Board Changed the picture for Step 2.
1

Safety and Symbols
This manual uses several symbols and abbreviations. The meaning of those symbols and abbreviations
are as follows:
Clip ring
Screw
Connector
Clamp
SEF Short Edge Feed
LEF Long Edge Feed
[A] Short Edge Feed (SEF)
[B] Long Edge Feed (LEF)
Trademarks
Microsoft®, Windows®, and MS-DOS® are registered trademarks of Microsoft Corporation in the
United States and /or other countries.
PostScript® is a registered trademark of Adobe Systems, Incorporated.
PCL® is a registered trademark of Hewlett-Packard Company.
Ethernet® is a registered trademark of Xerox Corporation.
PowerPC® is a registered trademark of International Business Machines Corporation.
Other product names used herein are for identification purposes only and may be trademarks of their
respective companies. We disclaim any and all rights involved with those marks.
2

TABLE OF CONTENTS
Revision Lists........................................................................................................................................................1
Safety and Symbols............................................................................................................................................2
Trademarks.....................................................................................................................................................2
1. Replacement and Adjustment
Paper Sensor.......................................................................................................................................................5
Controller Board...............................................................................................................................................10
3

4

1. Replacement and Adjustment
Paper Sensor
1. Open the right cover.
2. Main power switch cover [A] ( ×1, hook×3).
• The main power switch cover has three tabs: two on the left side (paper exit) and one on the
right side (right cover).
3. Paper exit tray [A].
5

4. Left upper cover [A] ( ×1).
5. Left rear cover [A] ( ×2, hook×1).
6. Cover [A].
• Remove this carefully in accordance with the notes described below.
1. Replacement and Adjustment
6

• Do not twist the cover to remove the cover as shown below. Otherwise, some hooks inside the
cover may be broken.
• Lift up the cover vertically to remove the cover as shown below.
Paper Sensor
7

7. 1 bin tray [A] ( ×1).
8. 1 bin tray unit [A] ( ×1, ×2).
1. Replacement and Adjustment
8