Riso Comcolor X1 Series User manual

Riso ComColor FW/GD/X1 Pre-Check
Before using your Riso ComColor after a long period of non-use
•Turn machine ON
•Wait until machine is finished warming up and in idle mode.
•Press the round [Home button] located on the lower left-hand corner [GD/FW] [ Mode button] upper left-hand
corner [X1] of the control panel to return to home screen.
•On FW/GD Perform machine Strong Head cleaning. From the home screen press [Maintenance] follow by [Head
Cleaning] select [Strong Cleaning]and press OK
•On X1 select [Functions] [Head Cleaning] and choose [Normal cleaning] or [Strong cleaning] and [OK]
•Test machine by running live jobs
If image output is not satisfactory on the FW/GD continue to next step. (not available
on X1)
FW/GD
FW/GD
X1
FW/GD
FW/GD
FW/GD/X1
X1
X1

Riso ComColor FW/GD/X1 Pre-Check
FW/GD Only
CAUTION: Certify that the ink cartridges are not near empty
•From the Home Screen, enter machine Test Mode area, using numeral keypad, press and hold [ * ] [ 8 ] [ #] until
passcode is requested. Enter (3214) as passcode and press OK.
•Using keypad, enter TM 09-3-068 press [start] key then [start] again to initiate Ink Circulation
This Test Mode will take approximately 10 minutes to complete
•Once the TM09-3-068 has completed, exit machine Test Mode area by pressing [STOP- red round button] followed
by the [Round Home button].
•Test machine by running live jobs