Ronbow Douglas 687411-FINISH Assembly instructions

INSTALLATION AND CARE GUIDE
DOUGLAS WALL CABINET
687411-FINISH

170713ronbow.comINSTALLATION SHEET
2
DOUGLAS Wood Cabinet
Model : 687411-FINISH
Tools Required
MATERIALS INCLUDED
1 wood cabinet
1 set velcro piece
2 mounting hardware
2 wood screws
MATERIALS NEEDED
1 2 X 4 supprt beam

170713ronbow.comINSTALLATION SHEET
3
DOUGLAS Wood Cabinet
Model : 687411-FINISH
Step 1:
Figure 1.
Cut the 2 x 4 support beam to size and place
behind the wall for extra support of your new
cabinet
PRE-INSTALLATION
See Figure 2.
Mark the location of the mounting hardware with
a distance between 9 to 9 1/2”.
Then screw on the mounting hardware gently to
allow the mounting hardware to rotate. Do not
overtighten.
Place the leveler on top of the mounting
hardware and rotate until it reaches a leveled
position.
Then tighten the mounting hardware.
Step 2:
Figure 2.
Prior hanging the cabinet, remove the velcro
adhesive film on the cabinet and gently hang
and press the cabinet to the wall to complete the
installation.
Step 3:
See Figure 1.
velcro piece
9”-
9
1/2”
Tighten lightly to allow
360° adjustment
INSTALLING THE CABINET

170713ronbow.comINSTALLATION SHEET
4
DOUGLAS Wood Cabinet
Model : 687411-FINISH
Figure 3.
Locate the screw nearest the hinge
cup and rotate clockwise or counter-
clockwise to move the door from side
to side.
Locate the screw furthest away from
the hinge cup and turn the screw
clockwise or counter-clockwise to
move the door from front to back.
Locate the screw pictured in Figure 6.
Turn the screw clockwise or counter-
clockwise to move the door from top
to bottom.
ADJUST DOOR HINGE
Figure 4.
Figure 5.
NOTE: When adjusting the door hinges keep in mind
to adjust the other hinges.
Side to Side
Front to Back
Top to Bottom
See Figure 3.
See Figure 4.
See Figure 5.
Side
Depth
Height