SCAN 3 User manual

SCAN 3
S
C
A
N
INSTRUCTIONS FOR
INSTALLATION AND USE
This manual is accompanied by a
pamphlet with General Instructions
for Installation. Edition 10.04 - GB
MONTERINGSVEJLEDNING
med brugs- og fyringsanvisning
Indhold:
Generelle råd og anvisninger . . . . . . . . . .2-3
Reklamationsret
Type- og miljøgodkendelse
Udpakning
Tilbehør til din pejs
Montering af kakler og fedtsten
Kvalitetskontrol
Anmeldelsespligt
Skorstenstjek
Skorstensløsninger
Bærende underlag
Brændbar eller ikke brændbar væg
Gulvplade
Varmefordeling
Justerskrue
Typeskilt
Produktionsnr.
Servicepakke
Monteringsvejledning. . . . . . . . . . . . . . . . .4-7
Tilslutning til eksisterende/muret skorsten
Tilslutning topafgang til stålskorsten
Forbrændingsluft udefra
Brugs- og fyringsanvisning . . . . . . . . . . . 8-10
Vedligeholdelse af pejseovnen
Håndtering af brændsel
Optænding og fyring
Fejlsøgning . . . . . . . . . . . . . . . . . . . . . . . . 11
SCAN 3
BRUGSANVISNING
TildenneBrugsanvisninghørerogsåen
generelMonteringsvejledning.Udgave03.03-DK
MONTERINGSVEJLEDNING
medbrug
s-ogfyringsanvisning
Indhold:
Generellerådoganvisninger..........2-3
Reklamationsret
Type-ogmiljøgodkendelse
Udpakning
Tilbehørtildinpejs
Monteringafkaklerogfedtsten
Kvalitetskontrol
Anmeldelsespligt
Skorstenstjek
Skorstensløsninger
Bærendeunderlag
Brændbarellerikkebrændbarvæg
Gulvplade
Varmefordeling
Selvlukkendelåge
Justerskrue
Typeskilt
Produktionsnr.
Servicepakke
Monteringsvejledning.................4-7
Tilslutningtileksisterende/muretskorsten
Tilslutningtopafgangtilstålskorsten
Forbrændingsluftudefra
Brugs-ogfyringsanvisning...........8-10
Vedligeholdelseafpejseovnen
Håndteringafbrændsel
Optændingogfyring
Fejlsøgning.
.......................11
Tildennemonteringsvejledninghørerogsåen
separatbrugsanvisningfordenenkeltepejs.
Udgave02/03-DK
Til dennemonteringsvejledning hørerogsåen
separatbrugsanvisning fordenenkelte pejs.
Udgave 02/03 - DK
Approved according to DIN 18891

1 Ashtray. The ashtray is placed below the combustion
chamber. Attention! Be careful when you empty ashes
from the stove. There may be embers left for up to 24
hours after the stove was last used.
2 Lid for ashtray. Under the ashtray you will find a lid to
put on top of the ashtray when you carry it out for empty-
ing.
3 Handle for shaking grate. The stove is equipped with a
shaking grate. When you activate the grate handle, the
ashes from the combustion chamber are emptied into the
ashtray.
4 Regulation for primary air. Turn the air valve in order to
open. The primary air is used when lighting and refuelling
the stove. It should always be closed during continuous
firing.
5 Regulation for combustion air. Push the button side-
ways. Left position is closed and right position is open.
The air is used for the combustion and regulates the
output of the stove.
The ashtray, shaking grate, and primary air should
always be closed during continuous firing.
Ceramic smoke deflector
In order to dismount the ceramic smoke deflector, lift up the plate,
hold it at an angle so that it is free of the fitting, and remove it
through the combustion chamber.
You have chosen a product from one of Europe's leading
manufacturers of wood-burning stoves. We are convinced
that your stove will be to your full satisfaction and give you
many hours of pleasure if you follow the advice and instruc-
tions of this manual.
Please read this manual as well as the General
Instructions for Installation before beginning the instal-
lation.
Congratulations on your new SCAN stove!
3
5
4
1
2
SCAN 3
Wood / briquettes Fuel kg/h (beechwood
max. 20% humidity)
SCAN 3 2,5 kg
Combustion air % 100
Primary air % 0
The ashtray, shaking grate, and primary air should
always be closed during continous firing.
Adjustment of the air

S
C
A
N
Adjustment of the handle
You can adjust the handle by loosening the screw
opposite the handle. The vertical position of the
handle can be adjusted with the other screw.
Accessories
For this model you can have the following accessories:
S
C
A
N
Handle
The door is opened by turning the handle counter-
clockwise.
Adjustment screws
The stove has two adjustment screws on the bot-
tom that can be used for levelling the stove.
Self-closing door (BA1)
The door is prepared with a self-closing function at the fac-
tory. If you tighten the spring with the hexagon spanner, the
door will close automatically when you let go of it.
• Lateral covering in soapstone or
ceramic tiles
• Top plate in soapstone or ceramic
tile
• Baking-compartment door
• Connection piece for fresh-air
intake
• Swivel grill
• Steel floor plate
• Large grill
SCAN 3
Stove
model
SCAN
Connecting
adaptor
mm
1
Density of
flue gas
flow
g/s
2
Flue gas
tempera-
ture
oC
3
Minimum
draft
Pa
4
Density of
flue gas
flow
g/s
5
Flue gas
temperature
oC
6
Minimum
draft
Pa
7
0,8
Minimum
draft
Pa
3180 - - - 9 310 15 12
With closed doorsWith open doors
Column 2 and 5 show the flue gas temperature in the connecting adaptor
Column 3 and 6 show the lowest/minimum draft in Pa by rated value
Column 7 shows the lowest/minimum draft in Pa by 0.8 x rated value
Data for calculation of the chimney
The stove can be prepared for an external air supply where fresh
air is let directly into the combustion chamber (must be mounted
from the factory).

Krog Iversen & Co. A/S - DK-5492 Vissenbjerg
692
177
518
943
1099
155
Warranty conditions
All SCAN wood-burning stoves and inserts are made of first-class material
and are subject to a strict quality control before they leave the factory.
However, if an error should occur, we back all SCAN wood-burning stoves
and inserts with an extensive, five-year limited warranty.
See also the General Instructions for Installation delivered with your
stove for more details.
Technical info
Rated output: 9 kW
Min./max.: 3 - 11 kW
Weight: 190 - 330 kg
Connection piece, diameter: int. 165 mm / ext. 178 mm
Production number
*
**
* To the middle of the rear outlet
** Connection to fresh-air intake
Distances to flammable
materials (mm)
Write the production number of your
stove here so that you have it at hand in
case you need to contact us.
You can choose between several
floor plates in different shapes and
dimensions for your stove. Please
contact your local authorities con-
cerning the security distances nee-
ded.
SCAN 3
200
200
500
800
800
Base plate
Radiation area
You should read this manual as well as the General Instructions for Installation before beginning the installation.