Siemens SAK 53 User manual

Installation instructions
8AA12358 - G0 - 05/11/2003 - UK - SNR 812358.0-001
Fig. 1
Fig. 2
Fig. 3
1. Product description
The SAK 53 remote keypad is used to operate and program
the Sintony central control units.
2. Supply package
The SAK 53 supply package contain the following :
- One SAK 53 remote keypad.
- One SLK 53 language kit with:
- installation instructions,
- operating instructions,
- one plastic front,
- one information label.
3. Mounting instructions
The SAK 53 is designed for mounting in dry indoor rooms. It
must not be exposed to dripping or splashing water.
Avoid touching and spilling any dust on the contact of the
keyboard.
3.1 Secure plastic front (fig. 1)
1 - Peel back the backing foil Qhalf way.
2 - Place the plastic front Win the recess.
3 - Stick down the plastic front in the recess whilst peeling
away the remaining backing foil.
3.2 Open housing (fig. 2)
1 - Release both locking tabs (A) and remove top section (B).
3.3Product overview (fig. 3)
-QMounting base,
-WCircuit board SMK 53,
-EPotentiometer for the LCD,
-RJumper for the buzzer volume,
-TTamper contact,
-YCover of the Keypad,
-UMounting holes,
-ICable inlet,
-OCable clip,
-PBack tamper contact screw,
-{E-Bus connection,
-}Connection not used,
-qPotentiometer for buzzer volume.
3.4 Fit housing (fig. 3)
1 - Pull the cable through the cable inlet I.
2 - Secure the mounting base U using two screws.
3 - Use the cable clip O.
Q
W
E
R
q
T
Y
ST1
U
I
O
P
{
}
s
LCD Remote keypad
SAK 53
SLK 53 UK A6E80114220

Fig. 4
Fig. 5
4. Wiring
4.1 E-Bus (fig. 4)
The E-Bus (B4+,B3,B2,B1-) must be connected to the central
control panel (A) and also to other accessories (B). For
additional information see the Control panel installation
manual
5. Close and seal the housing (fig. 5)
1 - Engage the cover in the top retainer (A).
2 - Close the cover (B).
3 - Glue the information label Qinside of the lid.
6. Start-up
6.1 Addressing
To enter an address in the remote keypad, simultaneously
press keys and and hold for approximately 5 sec.
6.2 Display address
To display the current address of the remote keypad,
simultaneously press keys and .
6.3 Test of displays
Simultaneously press keys and to activate all LEDs
and the buzzer.
7. Technical data
Supply (12 VDC) From the E-Bus
Power consumption min. 23,2 mA
Power consumption max. 120 mA
Operating temperature 0° C to +55° C
Housing ABS
Dimensions in mm H 110 x W 170 x D 32
Safety class IP 30
Environmental class II
Weight 250 g
The right to make technical changes to the described equipment without prior notice is
reserved - © 2002 -