SOMFY Elite Smart Shades R28 WireFree RTS Operating instructions

QUICK PROGRAMMING GUIDE FOR SOMFY®RTS MOTORS
(R28 WireFree & all Sonesse®30 / 40 / 50 RTS Models)
Page 1©2018 Elite Window Fashions™ 2018 v.1
Programming Mode
Before You Begin: Steps 1 to 7 must be completed to ensure proper shade programming & functionality. It is recommended to power only the
motor being programmed (disconnect power to all other motors). Motor will exit programming mode after 2 minutes of inactivity.
STEP 1: Connect Power: With the motor installed in the shade, connect power to the motor (120V, 12V or 24VTranformer or battery wand).

2) To increase motor speed: while shade is in motion, press and hold until motor jogs. Increase speed as desired.
When satisfied, press and hold to accept new speed.
3) To decrease motor speed, while shade is in motion press and hold until motor jogs. Decrease speed as desired.
When satisfied, press and hold to accept new speed.
1) Press and hold until the motor jogs. Shade will begin to move up and down automatically.
Resetting Sonesse® 40 / 50 RTS 120V AC Motors
Perform a dual power cut to delete all previous settings.
Page 2
Resetting R28 WireFree RTS 12V DC Battery Motors
Resetting Sonesse® 30 RTS Motors (24V DC & WireFree models)
Program
Button
Program
Button
Program
Button
ADJUST MOTOR SPEED (Sonesse®30 and Sonesse®50 DC models ONLY)
©2018 Elite Window Fashions™
Step 1 Step 2 Step 3 Step 4 Step 5:
Press and hold the
PROGRAM BUTTON on
your handheld or wall
remote until the motor
jogs 2x. Release when
motor stops jogging.
2018 v.1
Adding or Deleting a Remote or a Channel
To delete all previous settings and reset the motor to factory mode, use a paperclip to press and hold the
PROGRAM BUTTON located at the side of the motor. Hold for approximately 12 seconds, during which the
motor will jog 3 separate times. All remotes and limits will be erased (motor is now reset to factory mode).
To delete all previous settings and reset the motor to factory mode, use a paperclip to press and hold the
PROGRAM BUTTON located at the side of the motor. Hold for approximately 12 seconds, during which the
motor will jog 3 separate times. All remotes and limits will be erased (motor is now reset to factory mode).
Motor jogs 1x
2 Seconds 2 Seconds
10 Seconds