Sony IPELA PCS-G70 User manual

Revolabs Single Channel System — Sony PCS-G70 Setup Guide
This setup guide will guide you through the steps needed to properly connect a
Revolabs Single Channel System to a Sony PCS-G70 video codec.
Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Single Channel System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs Single Channel System
2. Sony PCS-G70 video codec
3. QTY 1 07-STEMIC-PPP Line-to-Mic Adapter Cable*
4. QTY 1 Female XLR—1/8” mono male cable* (i.e. Calrad 10-144)
* Optional Items

Connecting the Cables
1. Connect a Revolabs 07-STEMIC-PPP Line-to-Mic cable to the 2.5mm analog out-
put on the Single Channel System.
2. Connect a female XLR-to-1/8” cable between the male XLR connector on the 07
-STEMIC-PPP cable and the “MIC 1” port on the PCS-G70. Disregard the RCA
portion of the 07-STEMIC-PPP cable.
1. Push the TOOLS button on the remote control
2. Select SETUP
3. Select AUDIO to MIC
4. Select CTE to OFF
5. Select ECHO CANCELLER to ON
6. Save settings
Configuring the Sony PCS-G70 Video Codec
1
2