Soundoff Signal ETSSVBK04 User manual

1.800.338.7337 / www.soundo󰀨signal.com
ETSSVBK04 0220
1
100N/100J SERIES SPEAKER BRACKET (ONLY), GRILLE MOUNT
FORD F-150 2018 - 2020
ETSSVBK04
NOTICE:
Installers and users must comply with all applicable federal, state and local laws regarding use and installation of warning devices.
Improper use or installation may void warranty coverage.
To review our Limited Warranty Statement & Return Policy for this or any SoundO Signal product, visit our website at www.soundosignal.com/tech-services/returns/.
If you have questions regarding this product, contact Technical Services, Monday - Friday, 8 a.m. to 5 p.m. ET at 1.800.338.7337 (press #4).
Questions or comments that do not require immediate attention may be emailed to techservices@soundosignal.com.
ENHANCING SAFETY THROUGH INNOVATION
CONTAINS
QTY COMPONENT
1 Driver’s side hanging bracket
1 Passenger’s side hanging bracket
1 Speaker holding bracket
2 ¼-20 1” Length Hex Bolt
6 ¼” Flat Washers
2 ¼” Split lock washer
1 Installation Instruction sheet
1 Product Warning Card
FIG. 1
•HIGH CURRENT interconnects must be properly terminated. Poor crimp quality can cause heat build-up and
re. Follow crimp connector manufacturer instructions.
•DO NOT install this product or route any wires in the Air Bag Deployment Zone. Refer to vehicle Owner’s
Manual for deployment zones.
•Do NOT use system to disconnect headlights, brake lights or other safety equipment.
•Unit may become hot to touch during normal operation.
•Failure to properly install connectors, fuses or wiring may cause vehicle failure or re.
•Installation must only be performed by trained technician. Installer must determine vehicle wiring
conguration and proper integration of system.
•Use proper wire gauge. All power wires connecting to positive (+) or negative (-) battery terminal or local
chassis ground (-) must be sized to supply at least 125% of max. current and properly fused at power source.
•Install protective grommets when routing wire through rewall or metal.
WARNING
*Speaker Sold Separately
INTRODUCTION:
ETSSVBK04 PICTURED WITH ETSS100J SPEAKERS

1.800.338.7337 / www.soundo󰀨signal.com
ETSSVBK04 0220
2
100N/100J SERIES SPEAKER BRACKET (ONLY), GRILLE MOUNT
FORD F-150 2018 - 2020
ETSSVBK04
NOTICE:
Installers and users must comply with all applicable federal, state and local laws regarding use and installation of warning devices.
Improper use or installation may void warranty coverage.
To review our Limited Warranty Statement & Return Policy for this or any SoundO Signal product, visit our website at www.soundosignal.com/tech-services/returns/.
If you have questions regarding this product, contact Technical Services, Monday - Friday, 8 a.m. to 5 p.m. ET at 1.800.338.7337 (press #4).
Questions or comments that do not require immediate attention may be emailed to techservices@soundosignal.com.
ENHANCING SAFETY THROUGH INNOVATION
INSTALLATION:
1. Remove the front grille and shutter assembly from the
vehicle. Consult a local Ford service center for best
disassembly method. Keep all hardware.
2. Separate the grille and shutter assembly. The speakers
and brackets will sit between the grille and shutter
assembly, as shown in Fig. 2.
3. Place the hanging brackets through the holes in the top
of the shutter assembly and connect to the speaker
holding bracket with the hardware supplied, as shown in
Fig. 3.
4. Mount the speaker(s) to the speaker holding bracket
using the hardware supplied with the speaker and the
washer supplied with the brackets.
5. Assemble the grille and shutter with the speaker
brackets and speakers in between.
6. With the grille in place on the vehicle attach the hanging
bracket to the vehicle.
FIG. 2
SPEAKER PLACEMENT
FRONT OF VEHICLE
FIG. 3
DRIVER
SIDE
BRACKET
HOOD
LATCH
PASSENGER
SIDE
BRACKET