Spectrum Industries Aspire 37430 User manual

Assembly Instructions
0193940 Page 1 of 2
Assembly Instructions
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts or
accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Table for Aspire Workstation
37430
(4) 0105662
60mm 5/16-18 x 1”
Stem Caster
(22) 035594
#10 x 5/8”
PHSM
1
/
2”
Assembly tip: Do not tighten component fasteners completely
until all have been installed. Keeping them loose will help with
alignment between parts during assembly.
(2) 0171350
Leg
(1) 0176898
Worksurface (3) 0171406 Support bracket
(1) 0171352
Audience-side
panel
Attach casters to legs
1. Attach casters to legs and tighten.
1
X4
Leg
Attach legs to worksurface
1. Place the worksurface face-down onto a non-abrasive surface.
2. Orient the legs as shown with the ange toward the center.
3. Attach each leg to the worksurface with (2) screws.
2
Worksurface
Leg
Leg
(2) #10 x 5/8”
PHSM screws
(2) #10 x 5/8”
PHSM screws

0193940 Page 2 of 2 © 2023 Spectrum Industries Inc., All rights reserved.
1500 RIVER STREET, PO BOX 400, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
Attach audience-side panel
1. Attach the panel to the support brackets with (6) screws.
4
Install support brackets
1. Attach (2) of the support brackets to the worksurface as shown with
(3) screws each.
2. Install (1) screw at each corner to secure to the legs.
3. Attach the 3rd support bracket between the legs and secure with a
screw at each end.
3
Support bracket
Worksurface
Flip table upright
1. Carefully ip the table upright. This may take 2 people.
5
Support bracket
Support bracket
(1) #10 x 5/8”
PHSM screws
in each corner
(1) #10 x 5/8”
PHSM screw
(1) #10 x 5/8”
PHSM screw
(3) #10 x 5/8”
PHSM screws
(1) #10 x 5/8”
PHSM screw in
each corner
(3) #10 x 5/8”
PHSM screws