Spectrum Industries 55247 User manual

Doctorate/Masters
Drawer #55247
Assembly Instructions:
0101770X Pa
g
e 1 of 2
Before you begin, please make sure all parts and proper
quantities are included. Any parts damaged during shipment
must be reported within 15 days of receipt. To report
information regarding damages or if you have any questions,
please call 1-800-235-1262.
(3) 052901
8-32 x 3/8 PHMS
Tools Required:
Phillips head screwdriver
Figure 1
Figure 2
(2) 026064
1/4-20 x 5/8 PHMS (2) 035950
#8 x 3/4" Hi-Lo Screw
(1) 0101754
Lock Catch Plate
A. Disassemble the Outer Slides from the Inner Slides
by locating and depressing the black, plastic levers while
pulling the slides apart. Figure 1.
Disassemble Both Slides
1.
A
. Attach the Right-Hand outer slide to the lectern Divide
r
Panel using (3) 8-32 x 3/8" PHM Screws, and tighten
securely. Figure 2.
B. Attach the Left-Hand outer slide and bracket to the
worksurface inserts using (2) 1/4-20 x 5/8" PHM Screws.
Do not tighten these screws completely at this point.
Figure 2.
A
ttach Slides
2. Right-hand
outer slide
Inner Slide
Left-hand oute
r
slide and bracket
Divider Panel
Worksurface
(3) 8-32 x 3/8"
PHM Screws
(2) 1/4-20 X 5/8"
PHM Screws
RH Outer SlideLH Outer Slide
& Bracket

0101770X Pa
g
e 2 of 2
A. Align drawer inner slides with the outer slides mounted to the lectern and insert drawer. Figure 4.
B. Slide drawer in completely to fully engage slides.
Slide-in Drawer
4.
Figure 4
Drawe
r
A. Locate the two pre-drilled holes under the worksurface.
B. Attach the Lock Catch Plate using (2) #8 Hi-Lo Screws as shown in Figure 3.
A
ttach Lock Catch Plate to Worksurface
3.
Figure 3
Lock Catch
Plate
(2) #8 Hi-Lo
Screws
Worksurface
A. Open the drawer to access the Left-Hand slide bracket. Figure 5.
B. By reaching under the drawer, tighten the two worksurface screws from step 2 securely with a Phillips
screwdriver.
Tighten Bracket Screws
5.
Figure 5