Spectrum Mendota 30 Portable Lifeguard Chair User manual

1 800.791.8056 ~ www.spectrumproducts.com
Mendota 30”-36”-48”
Portable Lifeguard Chair
Owner’s Manual
Assembly and Installation
7100 Spectrum Lane
Missoula, Montana 59808
406.542.9781 ~ Fax: [phone]

2 800.791.8056 ~ www.spectrumproducts.com
Mendota 36” Assembly:
Tools Required:
Quad Head Bit
1/2” Open End Wrench
1/2” Socket and Ratchet
Mallet
1) Assemble Main frame together as
shown on one side in Detail A, making
sure to leave hardware loose, using:
8 - 5/16” x 3 ½” Carriage bolts
8 - 5/16” Lock Washers
8 - 5/16” Hex Nut
*Note: Set up the chair on a flat
surface, this will make installation of
hardware much simpler.
*Note: Set the heads of the carriage bolts into the HDPE lumber with
the mallet before tightening; do not over tighten the hex nuts.
2) As Shown in Detail B Screw together
the armrest stiffener (both sides) making
sure to screw into the existing holes,
using:
8 - 1 ½” Quad Head Screws.
*Note: It is important not to over
tighten the stainless steel screws,
this leaves a depression in the
surface where water and
contaminates can build up.
Armrest Stiffener

3 800.791.8056 ~ www.spectrumproducts.com
3) Tighten all hardware from step 1
4) As shown in Detail C, attach seat back to seat bottom (please use existing
holes) using:
3 –1 ½” Quad Head Screws
DETAIL D DETAIL C
5) Attach the seat back as shown in Detail D making sure to screw into
existing holes, using:
4 –2 ½” Quad Head Screws
1 ½” Quad Head Screws
2 ½” Quad Head
Screws

4 800.791.8056 ~ www.spectrumproducts.com
6) Then attach armrest as shown in Detail E using:
4 –1 ½” Quad Head Screws
DETAIL E
7) Attach wheels as shown if applicable using;
2 -BOLT CB 5/16"-18x3 1/2" TYPE 316
4 -FLAT WASHER 5/16"
2 -5/16" NYLOCK NUT