Spectrum InTouch 20 User manual

0111433R3 Page 1 of 6
CAUTION:
Before using this product, read this manual and follow
all safety and operating instructions.
Before you begin, please make sure all parts and
proper quantities are included. Any parts damaged
during shipment must be reported within 15 days of
receipt. To report information regarding damages or if
you have any questions, please call 1-800-235-1262.
To purchase parts or accessories, please contact us at
www.spectrumfurniture.com
1-800-235-1262
Thank you for purchasing Spectrum products!
Spectrum Industries, Inc
Chippewa Falls, WI 54729, USA
Owner’s Manual
55447CW InTouch 20 Secure Tablet Locker
InTouch 20 Secure Tablet Locker

InTouch 20 tablet locker security
0111433R3 Page 2 of 6
Safety Hardware Package Contents
• Read this owner’s manual before assembly or operation.
• If attaching to a worksurface, be sure it is stable and sturdy enough to
fully support the unit
• Do not allow children to operate
• For indoor use only. Do not install or store the unit where it will be
exposed to weather. Keep unit dry.
• For added safety, plug the unit into a grounded three-prong receptacle
controlled by a GFI (Ground Fault Interrupter) circuit breaker.
(2) 0111425
security bracket
Assembly / Setup
security bracket w/ 3/8”
mounting hole attached
to worksurface or oor
Lower ventilation
slot Figure 1B
The included security brackets can be installed to attach the locker to a se-
cure worksurface or oor for increased security. Fasteners are not included.
1. Choose fasteners appropriate to the surface you will be attaching to. Each security
bracket has a 3/8” diameter mounting hole.
2. Place each security bracket into one of the lower ventilation slots on each side of the
locker as shown in Figure 1B. The bracket can be located anywhere along these slots.
3. Mark the bracket hole locations on the worksurface or oor.
4. At the marked locations, drill pilot holes appropriate to the chosen fastener type and size.
5. Install fasteners and tighten securely.
(3) 5/16” holes are provided on the bottom panel to attach
the locker to a worksurface or oor for increased security.
Fasteners are not included.
1. Set the locker into position. (If attaching to a worksurface, be sure it is
stable and sturdy enough to fully support the unit.)
2. Choose fasteners appropriate to the surface you will be attaching to.
The (3) mounting holes in the bottom panel are 5/16” dia. Figure 1A.
3. Mark the (3) hole locations through bottom panel.
4. At the marked locations, drill holes in the worksurface or oor appropri-
ate to the chosen fastener type and size.
5. Install fasteners and tighten securely.
A. Bottom Panel Mounting Holes
B. Security Brackets
Figure 1A
(3) 5/16” holes available
for fastening locker to a
worksurface or oor
Spectrum recommends using the two attachment methods
shown below to maximize the locker security.

cord wrap above
each tablet
cord wrap above
each tablet
0111433R3 Page 3 of 6
Figure 2A
Routing power cords to tablets
1. With the 20-outlet power unit unplugged, plug up to 20 tablet chargers into the locker power
unit. Figure 2A.
2. Route the charge cords through the divider panel cutouts.
3. Using the cord wraps above each tablet storage slot, wrap excess cord while leaving
enough cord length to drop down to each tablet. Figure 2B.
4. Excess cords can be bundled with zip ties and stored under the bottom shelf if necessary.
Figure 2B
The wiring diagram below shows typical cord management for tablet power cords.
Excess cords can be bundled
here under bottom shelf
tablet
chargers
divider panel cutout
for routing USB &
power cords to tablets
divider panel cutout
for routing USB &
power cords to tablets
tablets
20-outlet
power unit

0111433R3 Page 4 of 6
Route USB hub cords to tablets (Hubs not included)
The wiring diagram below shows typical cord management when (4) USB hubs are used.
USB hubs are not included with the Secure Laptop Locker, but available as an option.
(See p.5)
Figure 3
1. Connect 3 USB cords to the “feeder hub”. Figure 3.
2. Connect the other end of each cord to a hub on the divider panel. (Up to 20 USB cords
can be connected to the hubs).
3. Route the cords through the divider panel cutouts.
4. Excess cords can be bundled with the included zip ties and stored under the bottom shelf.
tablet
divider panel cutout
for routing USB &
power cords to tablets
Hub #3
route power and USB cords
through the divider panel and
above each tablet
USB “feeder” hub #1
attached to top panel
cord wrap above
each tablet
tablet
Hub #1
Hub #2Hub #4
Excess cords can be bundled
here under bottom shelf
Note: The iPad®has a single cord for charging and
syncing. This cord must be moved from the power
plug to the sync hub for syncing. Many tablet de-
vices use this same type of conguration.
Some tablets have a separate power cord and
separate USB cord to accomplish both syncing
and charging functions. Please consult the owners
manual of your specic device for further information.
divider panel cutout
for routing USB &
power cords to tablets
“feeder hub” USB
cord to host lap-
top computer
cord wrap above
each tablet

0111433R3 Page 5 of 6
InTouch 20 Secure Tablet Locker Options
Charging & Syncing Hubs:
55448
Includes:
(4) 7-port Synchronizing USB hubs w/ cables
(1) 8-outlet power strip w/ rotating outlets
(8) 3” x 2” Velcro® strips
(15) Zip Ties
Power Strip Specs
•8-outlet surge protector with 6-foot cord
•Built to protect electronics
•Rotating outlets for ease of use; detachable
cord management clip for cable organization
•Right-angle plug keeps cord close to the wall
•Slim design
•Lifetime Warranty and $150,000 Connected
Equipment Warranty
Technical Details:
Height: 2.1 inches
Length: 13.5 inches
Width: 2.4 inches
55448 instructions available at www.spectrumfurniture.com
Rear View
Front View
USB Hub Specs
Standards
• USB specication version 2.0 1 (data rates of up to 480 Mbps)
• USB specication version 1.1 (data rates of up to 12 Mbps)
• OHCI
• UHIC
• VEHCI
Interfaces
• 1 upstream USB 2.0 Type B (female) port
• 7 downstream USB 2.0 Type A (female) ports (including 2 Fast
Charging ports)
Connectivity Rules
• Up to ve cascaded hubs
• Maximum cable length between each hub: 5m
• Up to 127 devices
Diagnostic LED
• Standard Mode (blue)
• Fast-Charge Mode (green)
Supplied Charging Current
• Standard Mode:
All seven USB ports - 0.5 A per port 2
• Fast-Charge Mode:
5 standard USB ports- 0.5 A per port 2
2 USB fast charging ports - 1.2 A per port 2
Power Input
• + 5 V / 3 A DC
Dimensions (L x W x H)
• + 3.94 x 2.2 x 0.9 inches (100 x 57 x 23 mm)
Weight
• 0.19 lbs (85 g)
Operating Temperature
• 32 to 104 °F (0 to 40 °C)
Storage Temperature
• -4 to 158 °F (-20 to 70 °C
Operating Humidity
• 5% to 95% (non-condensing)
Storage Humidity
• 0% to 95% (non-condensing)
Certications
• FCC
• CE
• C-Tick
• VCCI
• IC
• RoHS
Minimum System Requirements
• Computer with Windows®7, Windows Vista®, Windows®XP SP2,
Windows®2000 SP4
• Pentium 233-MHz or faster with 32MB RAM
• Computer with USB 1.1 Port
Note: The iPad® has a single cord for charging and syncing. This cord
must be moved from the power plug to the sync hub for syncing. Many
tablet devices use this same type of conguration. Some have a sepa-
rate power cord and separate USB cord to accomplish both syncing and
charging functions. Please consult the owners manual of your specic
device for further information.

0111433R3 Page 6 of 6
Warranty
WE WILL MAKE IT RIGHT FOR YOU!
Spectrum is committed to provide complete customer satisfaction. Each of our products are manufactured from the best materials available and each
product is stringently monitored throughout the production process through our P.A.C.E. program (Product Assurance to meet Customer Expectations).
Our Customer Service Help Line 1-800-235-1262 is ready to provide immediate attention to any questions, comments or concerns. We are available
to answer your calls Monday through Friday from 7 am to 5 pm CST, excluding observed holidays. In addition your product comments or concerns are
welcome via e-mail at: [email protected].
Warranty Statement
We guarantee all Spectrum products to be free of all defects in materials and workmanship, for the original owner, for a period of ten years. Any item
deemed defective by Spectrum or the original manufacturer, under normal use conditions, will be repaired or replaced at Spectrum’s discretion. This
warranty applies to all products manufactured and distributed by Spectrum except the products
listed below.
Items that have a varying warranty include, but are not limited to, the following:
• Adjustable Crank/Electric Desk Legs (1 yr)
• Flat Panel Desk Gas Cylinders (1 yr)
• Upholstered Soft-Goods (5 yrs)
• Adjustable Height & Stacking Chair Parts – including frames, gas cylinders, wood and plastic parts, and control handles (7 yrs)
• Adjustable Height & Stacking Chair Casters (2 yrs)
• Chair Upholstery & Textiles (2 yrs of normal use of Soft Goods, Adjustable Height, Stacking, Wood and Metal Chairs)
• Chair Upholstery - Graded-In Fabrics and C.O.M (no warranty)
• Height Adjustable Columns and Lifts (1 yr)
• General Use Casters (1 yr)
• Electrical – Electri-Pak, Power Communication Modules, and special order ECA electrical items (1 yr)
• Electrical - Power Strips & Electrical Timers (1 yr)
• Electrical Surge Suppressors (lifetime)
• Electrical - Retractable Power Cords (1 yr)
• Keyboard/Mouse Trays (1 yr)
• Flat Panel Monitor Arm – General Parts (5 yrs)
• Flat Panel Monitor Arm – Gas Cylinders (2 yrs)
• CRT Monitor Arm (1 yr)
Warranty is void if product is not used for its intended purpose or subjected to an unusual application, multiple-shift use, alteration, accident, abuse or
abnormal wear and tear. Representations of colors on-line and in printed materials are meant to be a close reference to the actual colors but not an
exact match. Slight variations in color and texture of wood stains, powder coating, laminates, fabrics and other materials are normal in different manu-
facturing lots; as such these variations are not considered defects.
DESIGNED FOR INDOOR USE ONLY – Unless specifically stated in the product specifications, Spectrum’s products have been designed and con-
structed for indoor use only. Moving or using outdoors, or on excessively rough surfaces, may cause damage to the products and will void the warranty.
If an outdoor application is desired please contact us to discuss potential custom design solutions.
The warranty, as stated above, supersedes any previous warranties and is effective as of 9/1/2010
925 First Avenue, PO Box 400, Chippewa Falls, WI 54729 Ph: 800-235-1262, 715-723-6750 Fax: [phone]
E-mail: [email protected] web: www.spectrumfurniture.com