SRC BMW-R1200GS-09-01-AL User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
No. Description Quantity Torque * (N-m) Remarks **
1 Skid Plate 1
2 Taper Ring M6 5
3 Special Pin 5
4 Screw M6 x 10 5 8-10 Use Liquid Thread Locker
SRC Design uses Metric System of Measurement and all dimensions are in Millimeters
* Recommended to use the Torque specified in the table
** Denotes Usage of Liquid Thread Locker in specified locations
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: BMW-R1200GS-09-01-AL / BMW-R1200GS-09-02-AL
Part Description: Engine Guard–BMW R1200 GS
Applicable to Finished colour versions of Silver and Black
Installation / Parts List / Bill of Material for Mounting

Copyright By SRC
Design and Specification are subjected to change
Page 2
MOUNTING DRAWINGS

Copyright By SRC
Design and Specification are subjected to change
Page 3
Mounting Instructions
The Underside of the Engine,
before mounting of the Skid Plate
(Engine Guard), looks like, as
shown in the drawing.
The 5 Mounting Holes (Front 2
holes at an Angular orientation,
and the back 3 at a Horizontal
orientation) can be seen, which
will be used for mounting the
Engine Guard.
Step: 1
Slip-in the Special Pin (3) –5 off,
as shown into the mounting holes.
These special pins, are made out
of Rubber, which act as cushions.
The projections, have threads, to
suit the Mounting threads in the
Underside of the Engine.

Copyright By SRC
Design and Specification are subjected to change
Page 4
Step: 3
The threads can be tightened as specified in the BOM
table.
The final mounted condition of the Skid Plate (Engine
Guard) is as shown, in the drawing below.
Step: 2
Slip-in the Taper Ring (4) –5
off and Screw (4) M6 x 10, as
shown, and secure the
threads on the Special Pin.

Copyright By SRC
Design and Specification are subjected to change
Page 5
General Instructions
1. We request you to pay attention to the Mounting Instructions in this document and follow the step-by-
step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the Accessory part to the
Vehicle. We have prepared this based on our experience and knowledge, related to the Vehicle, Part and
its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s accessory part. It
is advised to the User, to inspect and ensure the original state of all other Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving behaviour and/or the
stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it will help.
6. After Completion of the Mounting and before taking on a First ride, Ensure and Check all functions of
the Vehicle. It is always advised to check loosening of the fasteners after the first 50 kilo meters of ride and
at regular intervals.
7. To the maximum extent possible, our design use the current Mounting/Fitment of the Original
Equipment, so that Installation of these accessories will not affect the Payload or Function of the Vehicle or
the Part on which it is mounted to protect it
8. If any additional modifications are to be done, prior to the fitment of the accessories, it will be explicitly
specified in the instruction sheets