SRC H-AFT17-04-01-AL User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
No. Description Quantity Torque * (N-m) Remarks **
1 Top Rack 1
2 Taper Ring M8 4
3 Countersink Screw M8 x 40 4
4 Spacer 4
5 Nut M8 4 22-24
SRC Design uses Metric System of Measurement and all dimensions are in Millimeters
* Recommended to use the Torque specified in the table
** Denotes Usage of Liquid Thread Locker in specified locations
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: H-AFT17-04-01-AL / H-AFT17-04-02-AL
Part Description: Rack –HONDA CRF1000L AFRICA TWIN
Installation / Parts List / Bill of Material for Mounting

Copyright By SRC
Design and Specification are subjected to change
Page 2
MOUNTING DRAWINGS

Copyright By SRC
Design and Specification are subjected to change
Page 3
Step 2:
Slip-in the M8 (5) –4 off, as
shown, and secure the threads in
the Countersink screws.
Ensure a Square fit on the surface
of the Rear Panel/Spacer and
tighten it to torque, as per
specifications in the BOM Table.
Step 1:
Orient and Align the Top Rack (1), as
shown, in-line with the Mounting
holes of the Rear Panel.
Slip-in the Taper Ring M8 (2) –4 off,
Countersink Screw M8 x 40 (3) –4 off
from the top, and Slip-in the Spacer
(4) –4 off underneath the Top rack,
and on Top of the Mounting holes in
the Rear Panel.
Top Rack in final mounted
condition, is as shown above.

Copyright By SRC
Design and Specification are subjected to change
Page 4
General Instructions
1. We request you to pay attention to the Mounting Instructions in this document and
follow the step-by-step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the
Accessory part to the Vehicle. We have prepared this based on our experience and
knowledge, related to the Vehicle, Part and its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s
accessory part. It is advised to the User, to inspect and ensure the original state of all
other Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving
behaviour and/or the stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it
will help.
6. After Completion of the Mounting and before taking on a First ride, Ensure and Check all
functions of the Vehicle. It is always advised to check loosening of the fasteners after
the first 50 kilo meters of ride and at regular intervals.
7. We are showing here the Scope of Supply/ Installation/Parts list & BOM from SRC
8. To the maximum extent possible, our design use the current Mounting/Fitment of the
Original Equipment, so that Installation of these accessories will not affect the Payload
or Function of the Vehicle or the Part on which it is mounted to protect it
9. If any additional modifications are to be done, prior to the fitment of the accessories, it
will be explicitly specified in the instruction sheets.