SRC Y-WR155-02-01-SL User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: Y-WR155-02-01-SL - Y-WR155-02-02
Part Description: Radiator Guard –YAMAHA WR155 R
Installation / Parts List / Bill of Material for Mounting

Copyright By SRC
Design and Specification are subjected to change
Page 2
MOUNTING DRAWINGS

Copyright By SRC
Design and Specification are subjected to change
Page 3
The Original Radiator Guard
in motorbike
is shown in the drawing.
Step 1:
Remove the Original Mounting
bolts which holds the Radiator
Guard. is shown in the drawing.
Mounting Installation

Copyright By SRC
Design and Specification are subjected to change
Page 4
Step 2:
Orient and Align the Radiator Guard
RH (1) and Slip-in Washer M6 (5) –2
off and Screw bolt M6 x 12 (4) –2 off,
and
Slip-in the Original Screw
motorbike -3 off,( as shown ) and
through the Mounting point as shown
in Red colour.
Step 3:
Slip-in Washer M6 (5) –1 off and Screw
M6 x 10 (2) –1 off, and Slip-in the
Radiator in motorbike ( as shown ) and
through the Mounting point as shown
in Red colour.
The Final Mounted condition of the SRC
Radiator Guard as shown in the drawing.

Copyright By SRC
Design and Specification are subjected to change
Page 5
General Instructions
1. We request you to pay attention to the Mounting Instructions in this document and follow
the step-by-step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the
Accessory part to the Vehicle. We have prepared this based on our experience and
knowledge, related to the Vehicle, Part and its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s
accessory part. It is advised to the User, to inspect and ensure the original state of all
other Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving behaviour
and/or the stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it will
help.
6. After Completion of the Mounting and before taking on a First ride, Ensure and Check all
functions of the Vehicle. It is always advised to check loosening of the fasteners after the
first 50 kilo meters of ride and at regular intervals.
7. We are showing here the Scope of Supply/ Installation/Parts list & BOM from SRC
8. To the maximum extent possible, our design use the current Mounting/Fitment of the
Original Equipment, so that Installation of these accessories will not affect the Payload or
Function of the Vehicle or the Part on which it is mounted to protect it
9. If any additional modifications are to be done, prior to the fitment of the accessories, it
will be explicitly specified in the instruction sheets.