SRC H-AFT18-15-01-SL User manual

Copyright By SRC
Design and Specification are subjected to change
Page 1
Scope of Supply/Bill of Material & Mounting Drawings
Part Number: H-AFT18-15-01-SL / H-AFT18-15-02
Part Description: Rear Brake Reservoir Cover
-HONDA CRF1000L AFRICA TWIN Adventure sport
Installation / Parts List / Bill of Material for Mounting

Copyright By SRC
Design and Specification are subjected to change
Page 2
Mounting Instructions
Step: 1
The Mounting Hole, as
shown in the drawing to the
left-hand side, is already
available in the Motorbike,
which is used for mounting
the Rear Brake Fluid
Reservoir.
Remove the Screw and
Washer and Insert the SRC
Rear Brake Reservoir Metal
Cover as shown and tighten
the screw.
Final mounted condition of
the Rear Brake Reservoir
cover is as shown in the
drawing at the bottom.

Copyright By SRC
Design and Specification are subjected to change
Page 3
General Information
1. We request you to pay attention to the Mounting Instructions in this document and follow the step-
by-step procedures.
2. This Mounting Instruction manual is a “Do It Yourself” (DIY) fitment manual of the Accessory part to the
Vehicle. We have prepared this based on our experience and knowledge, related to the Vehicle, Part and
its functional aspects.
3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s accessory part. It
is advised to the User, to inspect and ensure the original state of all other Vehicle parts.
4. We request you to bear in mind, that the Installed part can change the driving behaviour and/or the
stability during driving or any other dynamic conditions.
5. If you have the appropriate tools and another person to assist you in the mounting, it will help.
6. To the maximum extent possible, our design use the current Mounting/Fitment of the Original
Equipment, so that Installation of these accessories will not affect the Payload or Function of the Vehicle or
the Part on which it is mounted to protect it
7. If any additional modifications are to be done, prior to the fitment of the accessories, it will be explicitly
specified in the instruction sheets.