Steelcase Verb 36" User manual

Verb™Easel
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2012 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
®
Page 1 of 6
939510100 Rev B
36”
56”
9/16”
7/16”

WRONG
Page 2 of 6
939510100 Rev B
®
1. Place leg on a clean, scratch resistant surface with holes
facing up.
2. Assemble top shelf to leg using two (2) 1/4-20 hex head
screws (2a). Repeat for other top shelf (2b).
NOTE: Second person required to help steady and keep
shelves upright as they are installed.
3. Place top tray into position and loosely install eight (8) (for
36” easel) or ten (10) (for 56” easel) #10 x 3/8” machine screws.
Ensure that the lower and upper end caps are aligned with the
steel shelves before driving screws. Leave screws loose. Make
sure the gap between the top cap and top shelf ends are aligned
(3a) and there is no gap between the end cap and the top tray
(3c) to ensure proper squareness. Tighten all #10 x 3/8”
machine screws.
2a
2b
1
3CORRECT
SEE NOTE
3b
3a
NOTE: Prop easel leg up to allow clearance for
the lower end cap alignment to shelves.
WRONG
CORRECT
TOP VIEWS
BOTTOM VIEWS
NO GAP between
the end cap and
the top tray.
3d
3c

Page 3 of 6
939510100 Rev B
®
4. Assemble lower shelf to leg using two (2) 1/4-20 hex
head screws (4a). Repeat for other lower shelf (4b).
NOTE: Second person required to help steady and keep
shelves upright as they are installed.
5. Assemble second leg to shelves using two (2) 1/4-20
hex head screws into each shelf.
4b
4a
5
NOTE: Use caution when driving screws.
Do not damage paint with your driver.

Page 4 of 6
939510100 Rev B
®
6. Place middle shelf into position (6a) and loosely
install six (6) (for 36” easel) or eight (8) (for 56” easel)
#10 x 3/8” machine screws into shelf (6b).
6b
6a

Page 5 of 6
939510100 Rev B
®
7. Hand tighten caster stem into each leg and secure
with 9/16 wrench. Tap each caster securely onto each
stem with a rubber mallet.
7

Page 6 of 6
939510100 Rev B
®
8. Using two (2) people, flip the easel upright onto the casters.
9. Inspect unit for squareness. If unit is square, go to step 10.
If the top track is twisted, loosen (do not remove) all sixteen (16)
hex head leg screws with the unit in the upright position (on
casters). Adjust unit as needed. Re-tighten hex head screws.
10. Tighten the machine screws that were installed in step 6,
making sure the tray is adjusted to its lowest point.
8
10
9