Stinger HEIGH10 SRK-JK11H User manual

®
PN: UN1810
USER GUIDE
INTEGRATED MULTIMEDIA DISPLAY
FOR JEEP WRANGLER JK/JKU
SRK-JK11H
®
®
®

23
StingerElectronics.com StingerElectronics.com
®®
AM/FM Radio............................18
BluetoothPhone.......................19
Pairing a Device...................20
BT Device Settings...................21
Contacts/Call Log..................22
Bluetooth Music........................23
SiriusXM
®
. ................................... 24
SiriusXM Replay™...................27
SiriusXM Lock Code................28
USB Media.................................29
Apple CarPlay
®
.........................30
Android Auto™ ........................31
iPod................................. . .........32
HDMI................... ................... ....33
AV In..........................................33
Cameras...................................34
Navigation................................35
Display Off........... ................. ...35
The Controls................................4
Getting Started...........................6
Selecting a Source.....................7
Setting the Clock........................7
Setting the Tabs..........................8
Audio Settings.........................40
Equalizer.................................41
Factory EQ.............................41
Crossover...............................42
Time Correction....................43
Toslink.....................................44
Gain/Volume........................44
WELCOME TO YOUR NEW
Enjoy the ride
THE BASICS THE SOURCES GENERAL SETTINGS TECH SPECS
AUDIO SETTINGS
VEHICLE SPECIFIC
Vehicle Info................................9
Gauges...................................10
Performance..........................11
Off-Road.................................12
Drivetrain.................................13
UserSettings............................14
Off-RoadCamera...................15
VehicleSettings............. ... ........16
USBPorts...................................17
Settings......................................36
Clock.......................................36
System Settings.......................36
Illumination.............................37
Backgrounds...........................38
Display.....................................38
Tabs.........................................38
Cameras.................................39
Reset Button............................45
Troubleshooting......................46
Specications. ........................ 48
Technical Support...................49
®

45
StingerElectronics.com StingerElectronics.com
®®
THE CONTROLS
Internal
Microphone
Reset
Button
Multifunction Knob
Press & Hold to Power On/Off
Turn to adjust Volume Up/Down
Press to Mute/Unmute
Home Button
Access the Home Menu
Press and Hold to launch Navigation.
When iGo Navigation is present, it will have
priority over phone based navigation.
Voice Button
Launches voice control
Tune/Track Up Button
Media control Next, Forward, Seek
Press & hold function in select sources
Tune/Track Down Button
Media control Previous, Back, Seek
Press & hold function in select sources

67
StingerElectronics.com StingerElectronics.com
®®
GETTING STARTED SELECTING A SOURCE
Back Arrow Exit
POWER UP!
With the vehicle ignition in the ON or
ACC position, Press and hold the knob
for 2 seconds to power ON/OFF.
The source will automatically default to
the last source used prior to powering
down.
You can adjust the audio volume at
start-up in Sound Settings on page 44.
The Information Bar is located at the
top of the screen. Depending on the
SOURCE, it will provide information
or content-sensitive controls. It also
displays temperature, time, phone
info and may contain BACK ARROW
and EXIT buttons.
Customizable TABS can be accessed by
swiping the up arrow at the bottom
of the screen. Tabs give direct access to
sources/settings and can be customized
as shown on Page 8.
The active Tab will be highlighted, and
sources that are not available will be
dimmed out. Once the Tabs are opened,
they will auto-close after 5 seconds, or
press the down arrow to close the tabs.
There are multiple ways to scroll...
Swiping Up/Down, Up/Down Arrows
SETTING THE TIME
1) Touch and hold the Time Display
on the Information Bar for 2 seconds
to access the clock settings.
2) Swipe or click the arrows to set
time and format.
3) Touch the BACK ARROW or EXIT
to save and exit.
2
1
To select a source, press the HOME
button.
The HOME MENU displays all Sources,
along with Settings, Audio, Camera
and Vehicle options.
SOURCES that are not currently
available are dimmed out.


QUICK TIP
Information Bar Source/Info
Temperature/
Time
Power
ON/OFF
Swipe Up
To Open TABS
HOME
Button
3

89
StingerElectronics.com StingerElectronics.com
®®
The Tabs can be congured to provide quick access to your favorite sources
or settings. The steps below show changing Favorites to Climate. Vehicle Info is
another option to consider adding to the Tabs.
CUSTOMIZING THE TABS
HOME BUTTON > SETTINGS > TABS
To Program a Tab:
1) Press the HOME button and select SETTINGS
2) From the SETTINGS menu, select TABS [1]
3) Select a Tab postition (1–7) on the
bottom row. [2]
4) Select the desired source or setting
from the options on the top rows. [3]
Now Favorites in position 2 is replaced
with Vehicle Info. Continue customizing or
touch EXIT (X) to return to current source
or the BACK arrow to return to SETTINGS.
1
3
2
BACK EXIT
Vehicle Info
1 2 3
7810 11
9
4
5
HOME BUTTON > Vehicle Info
Selecting Vehicle Info from the HOME Menu or Tabs will display information
and status for various vehicle systems.
BACK - Return to the previous screen.
Vehicle Info Menu - Provides access
to various vehicle display modes. The
current mode will be highlighted.
User Settings - Access tire pressure,
camera and GPS options.
Tire Pressure - Provides tire pressure and
low pressure warnings. Low pressure
warnings can be customized in User
Settings.
Malfunction Indicator - Displays current
malfunction indicators. Touch the
indicator for more information.
Door Closed/Opened - Indicates door,
and rear gate status. (Removed doors
show Closed)
Camera - Activates default camera.
Default camera can be set in User
Settings.
Transfer Case Status - Displays current
transfer case position.
GPS Coordinates - Displays GPS
information. Sensitivity can be adjusted
in User Settings.
Altitude - Displays altitude above/
below sea level.
Tire Angle - Displays front tire angle.
1
5
2
6
3
7
4
8
9
10
11
6

10 11
StingerElectronics.com StingerElectronics.com
®®
Vehicle Info > Gauges
To Change the Gauge Type:
Lightly tapping any gauge cycles
through the available gauge types.
Saving a Gauge Setup:
Press and hold either of the two Preset
buttons in the bottom corners to save
and later recall a gauge combination.
NOTE: To change the color of the
gauges, see Illumination Page 37
NOTE: To change the Units used for the
gauges, see Vehicle Settings on Page
16.
Available Gauge Types*:
Engine Coolant Temp
Engine Intake Temp
Engine Absolute Load
Intake Manifold Pressure
Ignition Timing
Engine Runtime
Fuel Level
Barometric Pressure
Battery Voltage
Engine Calculated Load
Engine Oil Pressure
Engine Oil Temp
Transmission Temp
Selecting Gauges from the Vehicle Info Menu will display eight gauges that can be
user dened and saved. Please note, gauge selection will vary with vehicle model
year and equipment.
Vehicle Info > Performance
Selecting Performance from the Vehicle Info Menu will display a digital
speedometer and tachomoter along with performance measurement options.
Best 0–60 MPH / Best ¼ Mile / Best 60–0
Whenever a performance measurement is achieved,
the results will be displayed. Use the left and right
arrows to recall Best measurements.
RESET
The RESET button will reset both Best and Last results.
Last 0–60 MPH / Last ¼ Mile / Last 60–0
Use the left and right arrows to recall the Last
measurement for each option.
*Gauge selection will vary with vehicle model year and equipment.

12 13
StingerElectronics.com StingerElectronics.com
®®
Vehicle Info > Off-Road
Selecting Off-Road from the Vehicle Info Menu will display digital pitch and roll
gauges along with the vehicle's GPS position, altitude and compass heading.
NOTE: When rst installed, the pitch and roll will show Calibrating. After a period
of driving, making left and right turns, the pitch and roll gauges will display
in degrees. The gauges will continually update as you drive, increasing the
accuracy of the gauges.
Vehicle Info > Drivetrain
Selecting Drivetrain from the Vehicle Info Menu will display a visual status
for the transfer case, axles, sway bar and tire angle.

14 15
StingerElectronics.com StingerElectronics.com
®®
Vehicle Info > User Settings Vehicle Info > Off-Road Camera
1
2
3
Low Tire Pressure Threshold [0–40 PSI]
Sets the threshold, in PSI, for the low tire
pressure warning shown on the Vehicle Info
display.
Note: This does not change the factory low
tire pressure warning shown in the instrument
cluster.
GPS Precision [Normal-High]
Sets the accuracy of the displayed GPS
coordinates.
Default Off-Road Camera
Select which camera activates when
pressing the camera button.
1
2
3
Selecting the Camera Icon from any of the Vehicle Info
screens will display the default Off-Road Camera selected
in the User Settings if installed. Along with the camera
image, an overlay showing pitch, roll, tire angle and other information will
be displayed.

16 17
StingerElectronics.com StingerElectronics.com
®®
Vehicle Settings
HOME BUTTON > Settings > Vehicle Settings
Selecting Vehicle Settings allows
changing the Units displayed in
the Vehicle Info screens to US or
Metric.
USB Ports
HOME BUTTON > USB
Primary USB1:
Apple CarPlay
Android Auto
USB Drive Media (Page: 29)
Charging
Firmware Updates
Secondary USB2:
USB Drive Media
Charging
Firmware Updates
Depending on the installation, there will be one or two USB ports. If there is
only one USB port, it will support all USB functions. If there is a second USB
port, one will support all USB functions and the other will support media,
charging and rmware updating only.
If the vehicle was equipped with
Uconnect and the PAC USB adapter
is installed, the factory USB port inside
the center console will be retained.
The PAC HDMI-USB adapter adds a
USB and HDMI port.

18 19
StingerElectronics.com StingerElectronics.com
®®
AM/FM RADIO Bluetooth PHONE
Station Presets - To assign a preset, go
to the desired station, and press and
hold a preset location until the preset
button highlights and station frequency
appears. A total of 18 FM and 12 AM
stations can be stored in memory.
AM/FM - Press to cycle through AM/FM
presets (FM1-FM2-FM3-AM1-AM2)
PTY Program Type - Indicates radio
station type.
Tune/Seek Down - Press and release to
Tune Down. Press and hold to Seek the
next available radio station.
Station Display - Displays current
frequency.
Number Pad - Touch to launch
the number pad for dialing phone
numbers.
Speaker/Phone - Switches phone calls
between the car speakers and the
phone handset.
Clear - Clear/delete last number
entered.
Call/Answer - Dials the number entered
on the phone or on the number pad.
Answers an incoming call.
End/Decline - Press to end an active
call or decline an incoming call.
ST Indicator - Indicates when the
current radio station is in Stereo.
Tune/Seek Up - Press and release to
Tune Up. Press and hold to Seek the
next available radio station.
Preset Bank - Indicates current preset
bank.
RT Info- Station/title/artist information.
DX/LOC - Changes the radio tuner
sensitivity. Touch to toggle between
Distant (DX) and Local (LOC).
Auto Preset - Touch to automatically
set the 6 presets with current location
radio stations.
Device Info - Displays the name of
the currently paired device, signal
strength and battery status.
Favorites - Customizable list of
favorite contacts.
Contacts - List of contacts from the
paired phone. Not supported by all
phones.
Settings - List of devices and settings.
Add or Delete devices.
Call Log - Recent Dialed, Received
and Missed calls.
2
1
123
66 7 8
10
9
11
5
5
2
2
66
3
3
7
7
4
4
88
10
9
10
11
9
34
5
9
8
Press the HOME BUTTON > Radio to select the Radio Press the HOME BUTTON > Phone to select the Phone
11
10
45
7